dissolve 200 gr od pure galactose in streile water at room temprature while stirring
Hydro power is based on water so that it is not contenue out put
To calculate the percent signal from a given current, you typically need a reference value, often the maximum current for a 100% signal. Assuming a common reference maximum of 20 mA (used in many industrial applications), you can calculate the percent signal as follows: [ \text{Percent Signal} = \left( \frac{11.3 , \text{mA}}{20 , \text{mA}} \right) \times 100 = 56.5% ] Thus, an 11.3 mA signal corresponds to approximately 56.5%.
about 5 yards if your slab is 4" deep
About 20 dollars an hour.
The starting salary of an electrical engineer in the United States is approximately $52,990 a year. The highest earning ten percent of electrical engineers make approx. $125,000 a year and median earners of the group make $82,000 a year.
A pharmacist mixed a 20 percent solution with a 30 percent solution to obtain 100 liters of a 24 percent solution. How much of the 20 percent solution did the pharmacist use in the mixture (in liters).
10
98 mL
To make a 20% dextrose solution, you need to dilute the 70% dextrose solution with water. You need to use 178.57 ml of the 70% dextrose and 321.43 ml of water to make 500 ml of 20% dextrose solution.
To make a 50% solution from a 20% solution, you need to concentrate the solution by evaporating some of the solvent. This will increase the concentration of the solute in the solution, making it 50%. Keep in mind this process should be done carefully, as it can be hazardous.
NOT: 15 ounces to make 10%Correct answer:Twenty ouncesCalculus:Let it be M ounces. Then:20%*(M ounce) + 5%*(40 ounce) = 10%*(M+40 ounce)20*M + 200 = 10*M + 400(20-10)*M = 400-20010M = 200M = 20
20%
Take 100 grams of 5% solution and do one of the following:Mix 95 g of it with 5 grams of sugar to end up with 100 g of 10% solution, or, when you are short of sugar:Evaporate 50 grams of water from 100 g of the 5% solution to end up with 50 g of 10% solution.
133.33
Let x represent the amount of 12% solution and (10-x) represent the amount of 20% solution. The equation to solve is: 0.12x + 0.20(10-x) = 0.14(10). Solving for x gives x = 4, so you need 4 gallons of the 12% solution and 6 gallons of the 20% solution to make 10 gallons of the 14% solution.
25 gallons
To make a 20 percent salt solution, dissolve 20 grams of salt in enough water to make a total volume of 100 milliliters. Start by adding the salt to a container, then gradually add water while stirring until you reach the 100-milliliter mark. Ensure the salt is completely dissolved for an even concentration. This solution can be adjusted proportionally for larger or smaller volumes.