Press Ctrl+B (or alternative go to "Schematic" --> " New Breakout")
Enter the Bus name followed by the number of pins you want and press OK.
example for name is
D0..2 -> creates Bus D with signals D0, D1 , D2
Check BIOS settings, make sure that the adapter is enabled. Check that the cable is not damaged and working properly. If you have burned the port. You can get a PCI extension port with Network Interface Port.
You would need a Video card with DVI port and a cable with a DVI connector on one side and two DVI/Analog connectors on the other side.
I can only think of two ways you can connect two computers if they don't have network cards: 1. Use a serial cable. All computers have serial ports, so this would be the easiest solution, though it will be a little slow. Look up directions online on how to do this. 2. If both computers have an IR (infra-red) port you can use that to connect the two. More input from FAQ Farmers: * or you can do it with a usb cable thingy, see it is like $5.00 and it works great if both have usb ports. by parallel cable by usb cable For newer macbooks hold down the t key to make it a drive then connect it to the desktop You can also buy ethernet / usb connectors. Pretty much its a wire with USB on one end and ethernet on the other. You just plug the USB side into your computer and now you have a ethernet port.
it works like this the 1.21 giggawatts of electricity that is generated by the plutonium that has been put into the back port of the de lorean is generated into the other electrically materialized parts and there it is
Port 0 is called true bidirectional port.............. swapneel
Port-Royal Logic was created in 1662.
connectors are use to connect into the port
Since about 2002, a USB port is the most likely port to be used for a printer. <><><> A 16 bit parallel port can be used if the PC is of the old type that has one, but only If the printer is of an older type that has the appropriate logic circuits, connectors and compatiible printer driver software.
none its logic
Attachment Unit Interface (AUI) is an interface that was used as Medium Independent Interface to connect to different connectors such as RJ45 & Coaxial connectors.
Use the component connectors instead.
no it works in a HDMI port
Sound port is a jack that usually has a sound output and input connectors which are used to connect headphones, speakers and microphone to a computer. Laptop and computer have different combinations of audio port.
In general, it's called a plug. The port it fits into is a socket. Different types of connectors have different names.
If the printer is of an older type that has the appropriate logic circuits, connectors and compatiible printer driver software, a parallel port and/or a serial portcan be used if they are available on the pc.
PS/2 connector (green: mouse, violet: keyboard) Serial Communications port VGA port Parallel port USB ports Audio connectors (pink: microphone, green: speaker, blue: line in) LAN port
You check if a usb device e.g. flash memory works in a good port. If it works, do that in the port you'd like to determine and see if your device is found.