The area to be concreted is sectioned off is small section across and up the incline. The hardcore base is fully compacted to prevent movement. The mix is made and is put into each section and allowed to go off before removing the horizontal board at the bottom of the concreted section. In most cases an additive is used to make the mix set quicker than normal thus preventing running. In the case of large areas (i.e. sides of roads, etc.) they actually used a preset slab which is lifted into place and has expansion joins inset to cope with heat changes in the concrete.
how much does it cost to form and pour concrete in Mobile, AL
about how much to pour a concrete slaba 12 x 14'
No. Concrete won't bond to concrete. It will end up cracking.
Yes
Yes, but you will need to reinforce with a wire mesh and then pour.
To pour concrete on a slope effectively, start by creating a sturdy formwork to contain the concrete. Use a mix with the right consistency and work quickly to prevent it from flowing downhill. Begin pouring at the lowest point and work your way up, using a screed to level the surface. Finish by troweling the concrete to achieve a smooth finish.
how much does it cost to form and pour concrete in Mobile, AL
about how much to pour a concrete slaba 12 x 14'
To properly install a concrete slab on a slope for stability and durability, you should first prepare the site by leveling the ground and creating a solid base. Next, install forms to contain the concrete and reinforce the slab with steel mesh or rebar. Pour the concrete evenly and use a screed to level it. Finally, finish the surface with a trowel and allow it to cure properly. Proper drainage and slope design are also important considerations for long-term stability.
POUR THE CONCRETE OVER THE BRICK
There are a number of ways in which you could prepare the ground to pour a concrete curb. You could level the surface and pour sand.
To pour a concrete pad correctly, first, prepare the site by leveling the ground and creating a form to contain the concrete. Next, mix the concrete according to the instructions and pour it into the form. Use a screed to level the concrete and a float to smooth the surface. Allow the concrete to cure for the recommended time before removing the form.
pour more concrete over the top and smooth it out
You pour liquid concrete into a frame and let it set.
No. Concrete won't bond to concrete. It will end up cracking.
Yes
Yes, but you will need to reinforce with a wire mesh and then pour.