0
What else can I help you with?
What is the difference between a half coupling and a full coupling?
half coupling used to take branch from header ie: 2" header to 3/4' branch. where full coupling used to connect to straight pipe. ie: 2" to 2" pipe connection.
What is the right connection fitting for a 2 inch PVC shower drain and trap to a 2 inch copper drain pipe?
A fernco or rubber fitting. This made of rubber and had hose clamps on it. You should ask for assistance at a hardware or plumbing shop for a 2" Plastic X 2" Copper Fernco or rubber coupling.
How can you connect a cut galvanized pipe without threads and a PVC pipe?
There is a coupling that almost all plumbing stores should have(including lowes). Its name can vary but is commonly called a dresser coupling or a raybolt.
What are merchant couplings used for?
To protected pipe thread. Do not use as a pipe coupling. Thread don't taper and the wall is to thin and could crack.
Who removed the rubber pipe from the basement?
its biff
How do you get a plastic bottle cap out of a pipe?
Cut the pipe and remove it, fix pipe with a coupling.
How do you remove broken barb coupling from pipe?
threaded pipe use an extractor
Can you patch a flex pipe for a muffler?
Yes! This can easily be done with a rubber pipe coupling bought at home depot.
How can I easily remove a Rain Bird Easy Fit Coupling?
To easily remove a Rain Bird Easy Fit Coupling, twist the coupling counterclockwise to loosen it, then pull it apart from the pipe.
What is pipe grooving?
Pipe grooved at end of pipe with grooving machine. Butt grooved pipe or fitting together and slip rubber seal onto end of each grooved joint, apply light coating of grease made for grooved piping on rubber seal. Coat split coupling for joint with grease also and put coupling around joint and clamp together tightly.
When connecting Rubber couplings for 2copper drain pipe should there be a bulge in the rubber between the two clamps at completion?
If the rubber coupling is bigger than the pipe, then it is going to bulge in the middle. This shouldn't be a problem. As long as the clamp is tight it shouldn't leak.
How do you repair a 4 inch ABS building drain with out taking apart the whole system?
Depends on what needs to be fixed. Cut out a section, use a regular coupling on one end and a rubber one on the other end. The rubber one slides over the pipe, position it to match the old pipe and slide it over the cut. It is held in place with hose clamps. Depending on where the break is, there may be enough play in the pipe to push the old pipe back and use a regular coupling on both ends. If it is just a hole, there is a saddle clamp or patch that is like a section of pipe cut lengthwise and is held in place with 2 U bolts. Rubber coupling is called a FERNCO coupling in case you were wondering.
How do you Connect a 3 inch ABS pipe to cast iron pipe?
Buy a 3" MECHANICAL COUPLING at any hardware or plumbing store. Made of rubber and has hose clamps.
Biff went into the basement to remove?
a small rubber pipe.
What did Biff go into the basement to remove?
A small rubber pipe
How can I effectively repair a galvanized pipe using a repair coupling?
To effectively repair a galvanized pipe using a repair coupling, follow these steps: Turn off the water supply to the pipe. Cut out the damaged section of the pipe using a pipe cutter. Clean the cut ends of the pipe with a wire brush. Slide the repair coupling onto one end of the pipe. Slide the other end of the pipe into the other side of the repair coupling. Tighten the screws on the repair coupling to secure it in place. Turn the water supply back on and check for leaks.
How can I connect corrugated pipe effectively?
To connect corrugated pipe effectively, use a rubber coupling or a specialized connector designed for corrugated pipe. Make sure the pipe ends are clean and cut straight before connecting them. Tighten the connectors securely to create a watertight seal.
