answersLogoWhite

0

Locate your main water line inside house and shut the water off. Cut pipe and place a tee solder into place. Run your line to exterior of house placing a shut off inside.. Test for leaks..

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How can I install a water line tap in my home?

To install a water line tap in your home, you will need to locate the main water line, shut off the water supply, drill a hole in the pipe, install a saddle valve or compression tee, and connect the new water line. It is recommended to consult a professional plumber for this task to ensure it is done correctly and safely.


Should your water softener be hooked up to your kitchen tap?

It is not necessary to have your water softener connected to your kitchen tap specifically. It is more common to connect water softeners to the main water supply line to treat water for the entire household. However, if you prefer to have soft water specifically in your kitchen, you can have a separate tap installed for that purpose.


How would you pressurize the system at the main water supply line?

If you are talking about a normal house, all you need to do to 'pressurize the system' is turn on the main valve, then open up each tap/faucet in turn until water is flowing freely.


Can you please show me where the nearest water fountain tap is located?

You can find the nearest water fountain tap in the hallway near the main entrance.


Where is the main water supply tap in a house?

Usually in basement coming through wall about 4 feet down from top of basement wall. The wall where water supply comes through at is usually in line with well or curb stop.


What do you do if you have a burst water pipe?

turn off main tap at building entry point


What is System separator for tap water connection?

A system separator for tap water connection is a device that is installed in a tap water system to prevent any contaminated water from flowing back into the main water supply. It helps to maintain the integrity and safety of the overall water supply by ensuring that no pollutants or chemicals can enter the public water system.


What is the difference between tap water and soda water?

you can tap tap


What is white stuff on concrete?

That white stuff is called "Efflorescence" its caused by minerals in ground water, tap water (sprinkler systems) moving through the surface and the water drying leaving powdery residue behind. Tim Mezen Green Handyman Services www.GreenHandymanServices.blogspot.com


Why does the cold water tap start cool then turn to hot then back to and stays cold?

Because, somewhere between where the cold water enters the house and the tap, the water resting in the pipe passes through a warm room. So you have to flush all that warm water out of the line before the cold water from outside gets to the tap.


How can I properly install a fridge water line to ensure a reliable and efficient water supply to my refrigerator?

To properly install a fridge water line for a reliable and efficient water supply to your refrigerator, follow these steps: Turn off the main water supply. Locate a nearby cold water pipe to tap into. Install a saddle valve or a tee fitting to connect the water line. Connect the water line to the fridge using a compression fitting. Turn on the water supply and check for leaks. Flush the line to remove any air or debris. Enjoy your reliable and efficient water supply to your refrigerator.


Why does tap water freeze faster than tap water?

No, it isn't faster, tap water freezes just at the same temperature as tap water