5000 volt
No, a 4160 volt motor with a high inertia load will use a resistor bank in the starting of the motor.
If the motor wire numbers are L1, L2 and L3, it is not a single phase motor. It is a three phase motor. Also for future reference, a 220 volt single phase motor does not use a neutral.
you can but if you do, you will/might: A) kill the motor,B)overload your 18 volt power supply, and C) maybe short a breaker if your power supply is also an ac to dc converter
Wow your in some serious stuff. Are you worried about rotation. 4160 is not something to be messed with if your not a qualified electrician or lineman. If you mess up you can have a big fire ball on your hands.
You can use an insulation rating 5000 volt to run 4160 volt supply.
5000 volt
No, a 4160 volt motor with a high inertia load will use a resistor bank in the starting of the motor.
317.025280 KILOWATTS = 317,025.28 WATTS
It could if you don't get the terminals and motor wires on the correct terminals.
If the motor wire numbers are L1, L2 and L3, it is not a single phase motor. It is a three phase motor. Also for future reference, a 220 volt single phase motor does not use a neutral.
you can but if you do, you will/might: A) kill the motor,B)overload your 18 volt power supply, and C) maybe short a breaker if your power supply is also an ac to dc converter
The switch will be wired in series with the motor. It is connected between the supply voltage and the motor's junction box. The switch will break the black wire while the white wire is just wire nutted together and is carried directly through to the motor.
Well first we need to generate voltage from electrical generator. Then if voltage are below 4160 volt step up Transformer is used and if voltage are above 4160 volt step down Transformer is used. Generally voltage produced from generator are low so we need to step up voltage to higher values such as 240 kilo volt to transmit them to longer distances to reduce power losses.
129 amps
Wow your in some serious stuff. Are you worried about rotation. 4160 is not something to be messed with if your not a qualified electrician or lineman. If you mess up you can have a big fire ball on your hands.
The recommended wire size for a 220 volt circuit according to the 220 volt wire size chart is typically 10 gauge wire for a circuit with a maximum of 30 amps.