SRAM based FPGAs cant be used for space application But we can go for Radiation tollerant Anti fuse FPGA.
Yes, FPGA is used in some ways in mobiles.
If you are using XILINX FPGA, try to insert a Microblaze processor to control your ADC.
FPGA Spartan is more efficient than the microcontroller. It is used to perform operations that cannot be properly done by microcontrollers; operations like high parallel or low latency operation.
fpga and plc are two completely different things. FPGA( field programmable gate arrays) are building blocks of electronic sysytem where as plc are systems. Comparing these two is like comparing engine with car.
used as mux and demux , used for implement haff adder $ full adder, by program it
Yes, FPGA is used in some ways in mobiles.
I am unable to provide specific PDF or PPT files as they need to be searched and downloaded from the internet. However, you can search for "FPGA in outer space PDF" or "FPGA in outer space PPT" on search engines or academic databases to find relevant materials on this topic. Make sure to verify the credibility and relevance of the sources before using them for your research.
FPGA is sutiable for complicated arch than CPLD. CPLD is very tiny when compared to the logic of FPGA so CPLD is faster.
micro controller is software and fpga is hardware
fpga has fine grain architecture and it can be programmed easily at field
fpga has fine grain architecture and it can be programmed easily at field
If you are using XILINX FPGA, try to insert a Microblaze processor to control your ADC.
FPGA and FPAA are both very different in nature and APLLICATIONS also.
FPGA Spartan is more efficient than the microcontroller. It is used to perform operations that cannot be properly done by microcontrollers; operations like high parallel or low latency operation.
BPSK is a modulation technique. It is used to modulate and demodulate the required signal. It can be virtually implemented in MATLAB. But to understand its physical behaviour, it needs to be implemented on FPGA board.
The major difference is that, a DSP is a chip which can be programmed based on our requirement, whereas an FPGA can be programmed to design a chip for our own purpose. FPGA can also be reprogrammed based on the changes in our application.
There is insufficient information in the question to properly answer it. You need to specify which FPGA you are interested in. Please restate the question.