for sure it affects the surface to a certain limit as you increase the paste on the surface and decrease the aggregat amount which may lead to surface abbraision...using surface hardner will help to strenghten the surface.
This may be possible if you prep the dry concrete with a latex bonding agent.
Yes it can, but for heavier use, mix a bit of latex into it instead of all the water. Sweep and then dampen the surface about an hour before you lay it.
The concrete slump test is used to measure an aspect of concrete. This test is used to measure the workable of concrete as well as its freshness and health.
I've heard of concrete sealer but don't know exactly what it is. What is it used for?
Yes the raw materials used are the same but design as per market requirement..!! Prestressed concrete is used for bridges and damms where concrete pouring is not possible
Yes, you can lay pavers over concrete for your outdoor project.
A curb machine is essentially the device used to place a concrete curb. "A curb machine is used to lay concrete molding, usually curbs, but it can also be used to lay concrete landscape edging and things like that." if your interested in purchasing complete curbing machine,trailer,and all accesories has been used for nine jobs MUST SELL!!!!!
Sand was used only to lay the bottom layer of the bed of the stone-paved roads. The Romans used Roman concrete. This type of concrete was different and, unlike modern concrete, sand was not used to make the mix.
Yes.
This may be possible if you prep the dry concrete with a latex bonding agent.
Yes, you can lay pavers over concrete to create a new patio surface.
Yes, Portland cement concrete pavement is often more economical in the long term than is asphalt concrete pavement. The asphalt concrete can be quite a bit faster to lay down and open to traffic, though.
To lay sheet vinyl flooring on concrete, first clean and level the concrete surface. Apply adhesive to the concrete, then lay the vinyl sheet carefully, smoothing out any air bubbles. Trim excess vinyl and allow the adhesive to dry completely before walking on the floor.
Yes it can, but for heavier use, mix a bit of latex into it instead of all the water. Sweep and then dampen the surface about an hour before you lay it.
To lay concrete slabs effectively and efficiently, follow these steps: Prepare the area by clearing debris and leveling the ground. Create a sturdy formwork to contain the concrete. Mix the concrete according to the instructions, ensuring the right consistency. Pour the concrete evenly into the formwork. Use a screed to level the concrete and remove any excess. Allow the concrete to cure properly before removing the formwork. By following these steps carefully, you can lay concrete slabs effectively and efficiently.
Generally, foundation contractors.
Yes, you can lay tile directly on concrete by using a suitable adhesive or mortar to secure the tiles in place. It is important to properly prepare the concrete surface before tiling to ensure a strong and durable bond.