Depends on the voltage.
Just use Ohm's Law Voltage = Current x Resistance Amps = Voltage Divided By Resistance Amps = 120 / 260
Read the specification plate on the motor to determine the amount of current that the motor uses, as well as the voltage and phase. Most likely, it will be a 3 phase motor, so you can't simply connect it to your house wiring, but without sufficient information, it is impossible to tell you all of the specifics. <<>> The code book rates the amperage of a three phase 40 HP motor by different voltages. at 200 volts - 120 amps, 230 volts - 104 amps, 460 volts - 52 amps and 575 volts - 52 amps. A breaker for a motor has to be sized to 250% of the motors full load amps. Also the wire size for a motor has to be 125% of the motor full load amps.
Current (amps)=Watts/Volts =2000/120 =16.75 =16.75 amps
No way of telling. to get amps you have to have a current flow, which you get when you connect a consumer to an outlet. Then the consumer will pull amps according to its wattage rating (Watts / Volts = amps) - assuming it's all hooked to a fuse with enough rating.
120 V x 0.75 A = 90 watts2 minutes = 120 seconds90 watts for 2 minutes = (90) x (120) = 10,800 watt-seconds = 10,800 joulesThe motor consumes 10,800 joules of electrical energy during that 2 minutes.If the motor is perfectly (100%) efficient, then that's the amount of work youcan get out of it.In the general case, the amouunt of work the motor can do is (10,800 joules) x the motor's efficiency.
voltage X amps = wats a motor may require 3 time that to start
If it's 120 v 4.8 amps that is about 450 watts.
A 1 horsepower motor typically draws around 10 amps at 120 volts and 5 amps at 240 volts. The actual amperage can vary depending on the efficiency and design of the motor.
5.8 amps
A 1 HP motor running at 120 volts will draw approximately 746 watts. This calculation is based on the formula: Watts = Volts x Amps.
Depends on the voltage. If you are running off 120 VAC, a 0.5 horsepower motor would draw 3.1 A.
To find the number of amps in 200 watts at 120 volts, you can use the formula: Amps = Watts / Volts. Therefore, Amps = 200 watts / 120 volts, which equals approximately 1.67 amps.
in a home6000/120= 50 ampswatts/volts=amps
1700/120 is 14.169 amps
160 amps at 12v.
160 amps at 12v.
The amps required for a device depend on its power consumption. You can calculate the amps by dividing the power rating (in watts) by the voltage (in volts) of the device. For example, a 1200 watt device plugged into a 120-volt outlet would require 10 amps (1200 watts / 120 volts = 10 amps).