current = voltage/resistance
Assuming the 240 volts is across the 100 ohm wire, 2.4 amperes
power = current * voltage
Resulting in the wire dissipating 576 watts... One hot wire!
Current is inversely proportional to resistance. If you double the resistance, you halve the current. Ohm's Law: Volts = Amps * Ohms Solve for Amps: Amps = Volts / Ohms
Ohm's Law states Voltage = Current x Resistance. You rewrite the equation as Current = Volts / Resistance to solve for current.
The voltage of a circuit with a resistance of 250 ohms and a current of 0.95 amps is 237.5 volts. Ohms's law: Voltage = Current times Resistance
Voltage across a resistance = (resistance) x (current through the resistance) =4 x 1.4 = 5.6If the ' 1.4 ' is Amperes of current, then the required voltage is 5.6 volts.
V = I*R, so take 100 volts and divide it by the value of the resistance to get the current. Current is measured in amperes.
What is the current running through resistor four?1 amps..!What is the current running through resistor one? 3 amps...!What is the current running through resistor three? 2amps..!What is the current running through resistor five? 3 amps..!What is the voltage drop running through resistor five? 45 volts...!What is the equivalent resistance through the parallel portion of the circuit? 6 ohmsAnswerA resistor is a conductor, albeit one with a higher resistance than a length of wire, so current passes through it without any problem. The magnitude of the current will, of course, be somewhat lower because of the additional resistance.
The formula you are looking for is R = E/I. Resistance = Volts/Amps.
10 volts applied to 5 ohms would cause a current flow of 2 amperes. Current = voltage divided by resistance.
It is a voltage (potential) applied to a load that causes a current to flow through the load. Ohm's Law encapsulates this principal and states Volts = Current x Resistance. In your example, the applied voltage would be 200 volts.
The three electrical quantities are current voltage and resistance. Current is measured in amperes (A) and is the rate at which electricity flows through a conductor. Voltage is measured in volts (V) and is the electrical force pushing the current through the conductor. Resistance is measured in ohms () and is the opposition to the flow of current. Current - measured in amperes (A) Voltage - measured in volts (V) Resistance - measured in ohms ()
The current through the wire can be calculated using Ohm's Law, which states that current (I) equals voltage (V) divided by resistance (R). In this case, the current would be 90 volts divided by 30 ohms, which equals 3 amperes.
Ohm's Law Voltage = Current x Resistance Answer is 15/300
U = RxI so 11x20=220 volts
If the resistance of the wire is 30 ohms and the voltage between the two ends of the wire is 45 volts,then the current through the wire isI = E/R = (45/30) = 1.5 amperes.
Voltage / Resistance = Current, you do the math
Current is inversely proportional to resistance. If you double the resistance, you halve the current. Ohm's Law: Volts = Amps * Ohms Solve for Amps: Amps = Volts / Ohms
Ohm's Law states Voltage = Current x Resistance. You rewrite the equation as Current = Volts / Resistance to solve for current.