answersLogoWhite

0

Usually half and half so take a regular bucket half water to half type N if looks too wet add a little more cement if its too dry add more water Be very careful when adding more water u could end up ruining it.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What are the characteristics of masonry cement?

Characteristics of masonry cement :Strength of the masonry cement is goodSetting property will be fine as that of lime mortarIt is used particularly for masonry construction.inday mabao


How do you mixes type s masonry cement?

1 bag of cement with 4.5 five gallon buckets of masonry sand.


What is masonry mortar?

Masonry cement is basically normal Portland cement with added ingredients to provide the plasticity required for masonry work. Masonry cements are pre-packaged primarily as either Type N Masonry Cement or Type S Masonry Cement. Other types are available for specific circumstances. Type N Masonry mortar is recommended for general use in building non-load bearing walls as well as for exterior veneer walls not requiring high strength. Type S Masonry mortar is recommended for use in all masonry below grade as well as in building exterior load bearing walls requiring high strength. DO NOT use masonry cement for concrete jobs


What is the sand to cement mix ratio for Type N masonry cement?

1:5 (cement:sand) is the best ratio


How much water is required in 1 bags of cement?

it depends on the type of mix and water cement ratio.


What is a masonry dam?

masonry dam is usually built by masonry that is basically stones,bricks and cement and in which the force that holds the dam in place against the push from the water is earth's gravity pulling down the mass of the dam


What type of drill bit should I use for drilling into a cement wall?

For drilling into a cement wall, you should use a masonry drill bit.


What is the best type of cement to use for laying bricks?

The best type of cement to use for laying bricks is typically a mortar mix that is specifically designed for masonry applications. This type of cement is usually a blend of Portland cement, sand, and water, and is formulated to provide strong adhesion and durability for bricklaying projects. It is important to follow the manufacturer's instructions and mix the mortar to the correct consistency for optimal results.


What type of drill bit is best suited for drilling into cement?

For drilling into cement, a masonry drill bit is best suited due to its ability to effectively penetrate hard surfaces like concrete.


What is the masonry mortar mix ratio for type N mortar?

Use for non-load application. Mix with sand to produce a mortar for bricks and blocks. Mix proportions by weight for TYPE N Mortar - 10 kg Masonry Cement - 35 kg Sand


How much extra type 1 cement do you add to bag mix to make type 3 cement?

Typically you would need about 30% more type I cement to attain the same early strength gain as Type III cement.


Can you use type S mortar for a shower pan?

No. Premixed Type S mortar contains lime, which will cause it to shrink and crack. Best to use Portland cement mixed with masonry sand and a small amount of water. Should be mixed to a nearly dry consistency and "dry-packed."