Usually. Going through the overflow drain gets you straight into the drain without having to make the sharp bend in the tub drain. There could be a trap that comes apart in the drain underneath if it is accessible.
is is most certainly a blockage in the sewer line. Call a plumber to come and check it out and clean your sewer line for you.
A right-hand drain applies usually to bath-tubs and means the drain is on YOUR RIGHT when you are standing in front of the tub.
Yes It just takes them a Little longer to drain in the unlikely event that they all drain at the same time.
You remove the existing tub shoe and related fittings and install a new assembly. In some cases a reciprocating saw will be needed to cut the shoe flange located inside the tub
The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
To determine if your tub is leaking from the overflow drain, fill the tub with water and observe if the water level rises above the overflow drain. If water is leaking from the overflow drain while the tub is filled, then it is likely that the tub is leaking from the overflow drain.
The drain breather on a tub is called an overflow drain.
Is the tub's overflow drain leaking and causing water damage in your bathroom?
To replace a tub drain and overflow, you will need to remove the old drain and overflow assembly using a drain key tool. Then, install the new drain and overflow assembly by following the manufacturer's instructions. Be sure to seal the connections properly to prevent leaks.
Yes, the gasket between the overflow pipe and the tub can go bad, or it can leak around where the pipe is attached to the drain.
One the end of the tub above the drain there is a plate. It may be where you close the drain off or it may just be a cover plate. It is open on the bottom edge and goes into the drain so that the tub cannot overflow.
The purpose of a tub overflow gasket is to create a watertight seal between the tub and the overflow drain. It prevents water from leaking out of the tub by ensuring that any excess water that reaches the overflow drain is directed back into the plumbing system instead of spilling onto the floor.
A tub overflow kit typically includes a overflow drain cover, gasket, screws, and a drain shoe. These components are essential for preventing water from overflowing out of the bathtub.
To remove a pop-up tub drain, you can start by unscrewing the overflow cover and pulling out the linkage and stopper. Then, use a drain key or pliers to unscrew the drain flange and lift it out. Finally, clean the area and install a new drain if needed.
This is called a direct drain and they are not easy to find compared to tub drains that drain via the overflow pipe. Watco and Dearborn Brass both make kits to do this, available in the US.
Can someone please assist. I am have the same issue. Toronto CA
The overflow valve in a tub is designed to prevent water overflow by allowing excess water to drain out before it reaches the top of the tub. This helps to maintain a safe water level and prevents flooding.