Neither. Bolt tensile strength is in pounds per square inch. You are confusing torque with bolt strength. Typically a bolt will be torqued to stretch the bolt and preload it to about 50% of its strength. The relation between torque T and preload P is T = 0.15DP where D is bolt diameter(inch), T is inch pounds and P is pounds. Then stress is P/A where A is bolt area and this stress is 1/2 of strength.
Note that torque in foot pounds is simply in lb/12, or 12 inch pounds = 1 ft lb
650 foot/pounds
foot-pound. That is the application of one pound(al) of force to an object with a lever at 1 foot distance from the point of application. Usually, a torque wrench is used to apply a specific force to a bolt, measured in foot-pounds.
1.5 (Sack of Barite = 100 pounds) (Cubic foot of Barite = 150 pounds) (Density of Barite - 2.087)
A W24x110 beam has a nominal depth of 24 inches and a weight of 110 pounds per foot. To find the total weight of the beam, you can multiply the weight per foot by the length of the beam in feet. For example, a 10-foot length of a W24x110 beam would weigh 1,100 pounds.
A 3000 psi (pounds per square inch) concrete mix is generally suitable for sidewalks, as it provides a good balance of strength and durability for pedestrian use. This strength can handle typical foot traffic and weather conditions. However, for areas with heavier loads or more severe conditions, a higher strength mix may be recommended. Always consider local building codes and conditions when choosing concrete for sidewalks.
How do I convert foot pounds of torque to a tensile strength
18 foot/pounds 18 foot/pounds
20 foot pounds.
184 foot pounds
1/4" Lexan weighs 1.56 lbs per square foot
650 foot/pounds
33 foot pounds
46 foot pounds on short bolts 54 foot pounds on long bolts + 90 degees
99-121 foot pounds plus 90 degrees, small bolts 27-33 foot pounds
Manual Transmittion - Flywheel to Crank - 105 Foot Pounds Pressure Plate to Flywheel - 33 Foot Pounds Automatic Transmittion - Flex Plate to Crank - 65 Foot Pounds
20 foot pounds for the head of a Yamaha blaster
if it is diesel engine 25 foot pounds