answersLogoWhite

0

Redundancy

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Engineering

How many contacts are in a relay?

A relay typically has multiple contacts, with the most common configurations being single-pole single-throw (SPST) or single-pole double-throw (SPDT). In general, a relay can have anywhere from one to several contacts, depending on its design and intended application. Some relays may have multiple poles, each with its own set of contacts, allowing for more complex switching functions.


Alloying with which metal iron gets fatigue resistance?

There is no one single answer to your question as various alloying materials will achieve this. There are also various forms of fatigue failure, for instance thermal and bending, which will be affected by what alloying material is present.


How do you connect 3 phase inverter to single phase supply?

It depends on the 3 phase inverter. If it is a 3 phase input then you will first need to get a single phase to 3 phase converter to simulate a 3 phase supply, if that is what this particular inverter is intended for then you will have a label saying 230v primary with a L & N connection point, and the output will be labelled as secondary, giving you the inverted power rating. This is a very expensive way of running machinery as the inverted power is no different in conumption to the single phase.


Single or Three phase Ac Circuit?

Both are possible. Single phase requires a neutral (or two phases, such as "Single-phase 240 V) to return the un-used voltage on the "down side" of the generating cycle. Three phases equal "each other out" on the up and down side. One phase generating positively while the other two are at various points of positive and negative on the sine wave to balance each other out.


What is the working principle of phase failure relay?

A phase failure relay monitors the incoming three phase service lines. If the lines become reversed or loss of one phase causing single phasing, the relay's internal contacts change status. In control panels the control voltage usually is connected through the phase failure relay's auxiliary contacts. If any line anomalies occur the control voltage is cut off and the panel becomes inoperable. Once the line fault is corrected the fault relay senses that everything is alright and then allows the control voltage to power the control panel again.