A: They are applied both and combination of both
Ohm's law states that the current in a circuit is inversely proportional to the circuit resistance. There is a single path for current in a series circuit. The amount of current is determined by the total resistance of the circuit and the applied voltage.
If you add a second resistor, the resistance of series circuit will increase.
To find the total resistance in a series circuit, you can use Ohm's Law, which states ( R = \frac{V}{I} ). Given that the voltage (V) is 12 volts and the current (I) is 0.5 amps, the total resistance (R) can be calculated as ( R = \frac{12 , \text{V}}{0.5 , \text{A}} = 24 , \Omega ). Therefore, the total resistance of the circuit is 24 ohms.
The total resistance in a series circuit is determined by adding (summing) the individual resistances of each component in the circuit.
86k. Resistance in series is the sum of the individual resistors.
Yes
No
Power cables.Duh
Ohm's law states that the current in a circuit is inversely proportional to the circuit resistance. There is a single path for current in a series circuit. The amount of current is determined by the total resistance of the circuit and the applied voltage.
resistance
It has 8 parallal lines:)
The net force would be the difference between the applied force and the air resistance. If the applied force is greater than the air resistance, then the net force would be in the direction of the applied force. If the air resistance is greater than the applied force, then the net force would be in the opposite direction.
When the current increases as a voltage is applied to the bulb it causes the bulb's special wire filament to get so hot that it glows very brightly. The heating causes changes in the normal electron lattice of the filament, creating more barriers to the flow of the electrons and therefore the resistance of the wire increases as it gets hotter.
The resistance of a series circuit is simply the sum of the individual resistors.
If you add a second resistor, the resistance of series circuit will increase.
Resistance is due to a property specific resistance of material. In no way resistance depends on the voltage applied. This is the case of ordinary conductor. But in case of semi conductor or insulator there may be chances to get a variation of conductance and hence resistance due to potential applied.
Resistance isn't lost. The largest voltage drop will occur across the largest resistance in a series circuit.