Current flowing through a device depends on resistance offered by that device.
You can't really separate them. It's the current flowing through your body that does the damage, but the value of the current depends on the voltage across your body -the higher the voltage, the higher the resulting current.
The current flowing through a transformer's secondary is the current drawn by the load, so it will be exactly the same as the current flowing through your induction motor -assuming that is the load. Don't really understand the point of your question!
To limit the current flowing through the primary circuit.
electrical burns
You'll see a voltage drop across a resistor if current is flowing through it. It only has to be a part of a complete circuit, i.e. one in which current is flowing.
The strength of electromagnet depends on the electric current flowing through the core because when the current is stopped, the core is no longer magnetized and the rate of change of flux linkage.
The number of electrons flowing through a wire depends on the current passing through it. One ampere of current corresponds to approximately 6.24 x 10^18 electrons flowing through the wire per second.
Electrical energy depends on factors such as the voltage of the system, the current flowing through the system, and the time for which the system is consuming power. These factors combine to determine the overall amount of electrical energy used by a device or system.
The factors on which the current through an electrolyte depend are: (i) Nature of electrolyte (ii) Concentration of the solution (iii) Temperature
You can't really separate them. It's the current flowing through your body that does the damage, but the value of the current depends on the voltage across your body -the higher the voltage, the higher the resulting current.
The electric current encounters resistance while flowing through a conductor, which results in the conversion of electrical energy into heat. This resistance is impacted by factors like the material of the conductor and its dimensions.
The amount of current flowing in each branch of a parallel circuit depends on the resistance of each branch. The branch with less resistance will have more current flowing through it, while the branch with more resistance will have less current flowing. Each branch acts independently because they provide multiple paths for current to flow.
The three factors are: the material of the conductor (resistivity), the current flowing through the conductor, and the time duration for which the current flows.
The strength of a magnet(electromagnet) made by flowing electric current through a conducting coil depends on magnitude of current. . .
Yes, a solenoid will still have a magnetic field even if there is no current flowing through it.
The strength of an electromagnets magnetic field depends on:The type of core metalThe ability of the wire to carry current (its material and thickness)The number of turns of the wiring around the coreThe voltage/current of the electricity going through the wire.
The direction of the magnetic field produced by an electric current flowing through a wire is dependent on the direction of the current. The right-hand rule can be used to determine the direction of the magnetic field relative to the direction of the current flow.