0
What else can I help you with?
What is the purpose of the zener diode in a power supply?
to limit the voltage or regulate the same.
What is the purpose of a diode in a cordless drill or power screwdriver?
it controls the speed. when the diode is busted it gains into fullspeed
Does photo diode requires supply voltage?
A: it requires a source of power only if it has to perform any usage
Why there is no current when two terminals of the diode are shorted?
There must be a break in the power supply elsewhere in the circuit. I suggest a blown fuse The only diode that generates electricity is a solar cell
Advantages of h bridge over other bridges?
h bridge can used as to supply the power in both directions
What is the purpose of the zener diode in a power supply?
to limit the voltage or regulate the same.
What is the purpose of a zener diode when placed near the output in a common power suplly?
The purpose of a zener diode connected at the output of a common supply is to stabilize the output voltage in case a load is connected to it.
What is the purpose of a diode in a cordless drill or power screwdriver?
it controls the speed. when the diode is busted it gains into fullspeed
What is the purpose of a diode in a cordless drill or power screw driver?
The purpose of a diode in a cordless drill or power screw driver is to allow electricity to flow in one direction only and blocks the flow in the opposite direction.
The diode which used in power supply design is called?
Type oke.io/ and X5sp and click enter, you will get your answer.
What are some practical uses of diodes?
Diodes are largely used for changing AC into DC. A half wave diode bridge will use two diodes for this purpose. A full wave bridge uses four diodes to accomplish this task.See related links below.
What is diode peak current in 12 volt power supply?
A: Diodes peaks current can exceed the forward steady sate current by a big factor for a short time without destroying itself. It will destroy itself if the power dissipation is exceeded. The answer to your question is the peak voltage has absolutely nothing to do with a 12 volts power supply or any other voltage power supply it has to do with the diode itself
What is the main purpose of a fan in the power supply on ATX systems?
cooling the power supply circuity
What is dve switching power supply used on?
EZ Bridge
Does photo diode requires supply voltage?
A: it requires a source of power only if it has to perform any usage
What is the purpose of a battery in a power drill?
To supply the power to the drill.
How do you find voltage rating of zener diode?
It should be marked, either on the diode or on the box it came in. If you can't find the mark, then you have to measure it yourself. Take the zener diode, a battery or DC power supply, and a resistor. Wire them all in series, with the NEG (cathode) end of the diode closer to the POSitive side of the battery or power supply. Connect your voltmeter across the diode, and slowlyincrease the power supply output voltage while watching the meter. You'll see the voltage across the diode increase slowly, tracking the power supply, until you reach the Zener voltage. At that point, the voltage across the diode won't increase any more; it'll just stay there at its 'reverse breakdown' voltage, which is the Zener voltage. (If the voltage across the diode goes to around a volt and won't go any higher, the polarity is wrong. Reverse either the diode or else the power supply.) You probably want a wild guess at what the value of the resistor should be. That's difficult to specify if I don't know the power rating of the Zener diode you're testing. I'm going to make the following suggestion completely in the blind: Select the resistor to limit the series current to 30 mA even if you have to crank the power supply up to 50 volts. R = 50/.03 = 1.5 to 2 K-ohms, rated for a couple of watts.
