On Circuit Resistance = Close to the total load Resistance. Off Circuit Resistance = Near Infinitive High Resistance.
Wheatstone bridge is used to calculate the resistance of unknown resistor in the circuit.
The resistance of a Silicon Controlled Rectifier (SCR) anode and cathode is typically very low when the SCR is in the forward conducting state, allowing current to flow easily. In the reverse state, the resistance is very high, effectively blocking current flow. The exact resistance values can vary based on the specific SCR model and operating conditions, but the general principle remains the same: low resistance in the forward direction and high resistance in the reverse direction.
yes , it has high resistance between collector and emitter on the off state.
cement
Factors affecting the state of a substance include temperature, pressure, and the intermolecular forces between the particles of the substance. Changes in these factors can lead to a substance transitioning between solid, liquid, and gas states.
Each State as different railway gauges. MF
Consumer behavior is affected by the earning power of the consumers. That means it is affected by the state of the economy.
Several physical factors affect the capacity, including the quantity of active materials; the number, design, and the dimensions of the plates; and the electrolyte concentration. Operational factors affecting capacity include discharge rate, charging method, temperature, age, and conditions of the cell or battery.
Materials with zero resistance are called superconductors, which allow electrical current to flow through them without any loss of energy. Superconductors display this property at very low temperatures, reaching a state of zero electrical resistance known as superconductivity.
Consumer behavior is affected by the earning power of the consumers. That means it is affected by the state of the economy.
earnings and growth prospects,news of new products or planned services and the general state of the economy
Factors affecting states of matter include temperature, pressure, and intermolecular forces. As temperature increases, substances can change from solid to liquid to gas. Pressure can also affect the state of matter, with higher pressure favoring a more condensed state. Intermolecular forces determine how tightly particles are held together in a substance, influencing its state.
The cold resistance of a bulb can be approximated by measuring the resistance of the filament with a multimeter when the bulb is turned off and at room temperature. The resistance measured in this state can give an estimation of the cold resistance of the bulb. Keep in mind that this value may not be exact due to factors like the temperature coefficient of resistance and the non-linear behavior of the filament's resistance.
Evaporation occurs when water particles become agitated enough that they shift from water state to gaseous state. This phenomenon occurs when water is heated or put under huge amounts of pressure.
Speed of whisk, length of time whisking, cleanliness of egg (i.e. no yolk), state of bowl (e.g. needs to be clean and dry) etc.
The phenomenon where the electric resistance of superconducting materials suddenly drops to zero is called superconductivity. This occurs when the material is cooled below a critical temperature, specific to each material, at which it transitions into a superconducting state. In this state, the material can conduct electricity without any loss of energy due to resistance.