In an ammeter, the magnitude of the electric current - that which is measured in amperes - is measured via the magnetic deflection it causes in a needle. Note that this measures the flow of electric charge; it doesn't tell you specifically whether what is moving is electrons.
Electron flow is known as current. SI unit is Ampere
It is used to measure the rate of flow of liquid & glasses
A Rotameter is a device that measures the flow rate of liquid or gas in a closed tube. It is occasionally misspelled as "rotometer." It belongs to a class of meters called variable area meters, which measure flow rate by allowing the cross-sectional area the fluid travels through to vary, causing some measurable effect.
"I" represents the current which is the flow of electric charge. Impedance is the measure of the opposition to the flow of current at a given voltage usually in a.c. circuits.
the ratio of the distillate mass flow rate to the mass flow rate of the steam used
Amperes, milliamperes, microamperes, etc.
The flow rate of a fluid can be measured by techniques such as using a flow meter, which is a device that quantifies the amount of fluid passing through it over a specified time period. Flow rate is typically measured in units such as liters per minute or cubic meters per second.
Electron flow is known as current. SI unit is Ampere
It is an old measure for rate rate of flow.
You can slow down electron flow by increasing resistance in the circuit, using resistors for example. By increasing the obstruction to electron flow, you reduce the rate at which electrons can move through the circuit. Additionally, lowering the voltage in the circuit will also slow down electron flow.
Electron flow is known as 'current' the unit of current is an amp
conductivity. The answer you need is as follows. Heat energy is measured in Calories or Joules or BTU (British thermal units ). Heat flow Rate is measured using the units called Calories per Hour, or BTU/ Hr, or Joules/Hr
The purpose of a flow meter is to measure the flow of either air or water. They allow one to measure the total volume of air or liquid flow and the rate of the flow.
Linear flow rate can be calculated using the formula ( Q = A \cdot v ), where ( Q ) is the flow rate (volume per time), ( A ) is the cross-sectional area of the flow, and ( v ) is the average linear velocity of the fluid. To determine the flow rate, measure the cross-sectional area of the pipe or channel through which the fluid flows, and multiply it by the velocity of the fluid. Ensure that all units are consistent, typically using liters per second for flow rate, square meters for area, and meters per second for velocity.
because copper atom has one electron in outer shell and easy to to energize to flow to other copper atom we now that the rate of flow of electron is current
Amperage or Amps is a measure of is the flow rate of electrical current that is available.
The standard units used to measure the rate constant in a chemical reaction, known as kc units, are typically expressed in moles per liter per second (mol/L/s).