Leading power factor has no advantage as the apparent power will be greater than true or active power...
So power factor should be as close to unity as possible...
Lagging p.f. causes high currents in line, whereas leading p.f. causes over-voltages.
No. Your energy meter monitors the supply voltage and the in-phase component of the load current, so improving your power factor will have no effect on your energy consumption and, therefore, your electricity bill.
supply
Advantage of regulated power supply.
It is due to presence of form factor(Kf) in the emf equation of Alternators and transformers. Value of form factor is 1.11.
A load with a poor power factor draws extra current from the power supply, meaning that there will be more of a voltage-drop in the supply. As an example, if the load is 6 kW on a 240 v supply, the current drawn is 25 amps if the load has a power factor of 1. The kVA is equal to the kW. But if the load has a power factor of 0.8 it needs to draw 7.5 kVA for a power of 6 kW, which is a current of 31.25 amps, so there is more of a demand on the power supply wiring etc. The transmission losses increase by 56% with the extra current. In both cases the customer is charged for power used, 6 kW. That is why the supply companies do not like loads with a poor power factor and sometimes charge commercial customers more for a poor power factor. That in turn makes it viable for the customers to correct the power factor of the load they place on the supply.
For a residential consumer, power-factor improvement has absolutely no effect on one's electricity bill. Adding power-factor improvement capacitors at the point of supply will have absolutely no effect upon the operation of the load circuits, but it may act to reduce the supply current. But reducing the supply current will not reduce one's energy consumption.
Advantage of regulated power supply.
No. Your energy meter monitors the supply voltage and the in-phase component of the load current, so improving your power factor will have no effect on your energy consumption and, therefore, your electricity bill.
Improving the power factor of an industrial load acts to reduce the load current delivered by the electricity utility company, enabling them to reduce the amount of copper used in the supply lines, transformers, circuit breakers, etc. It also prevents the electricity utility company imposing a penalty charge applied to the factory's energy bill. The most common method of improving power factor under these circumstances, is by installing a capacitor bank at the supply's point of entry at the factory. It is also possible to install capacitors at individual inductive loads. Power factor improvement does not apply to residential loads, and any company offering 'power-factor improvement' capacitors for residential loads is a scam.
ATX is the form factor.
supply
power factor meters are connected across the supply
Advantage of regulated power supply.
Money supply is determined exogenously by the monetary authority usually central bank of a country.
The mother board, power supply, and chassis
It is the factor when they change they cause supply curve to shift to either left or right.
Bank rate