answersLogoWhite

0

You have to undo the aerator at the end of the faucet and clean the screen or plastic water saver out. It will be plugged with sand or sediment.

User Avatar

Wiki User

16y ago

What else can I help you with?

Continue Learning about Engineering

What causes one bathroom upstairs to have very little water pressure in the shower and bathtub but the other bathroom has plenty?

Insufficient water pressure or incorrect pipe sizing


How do you fix low water pressure due to calcium build up?

If you notice reduced pressure in one of your faucets and not other faucets, and notice that the flow is reduced in both the hot and cold sides of the same faucets then it is probably your aerator. If it is only on one side of your faucet (hot or cold side) then it is probably a mineral buildup in the valve of the faucet (you can clean that side or replace the valves components.) You can also try to loosen the mineral deposits by... first removing the aerator then turn off the supply line valve ( the valve under the sink, several times) to try and dislodge the mineral deposit; if you leave the drain stopper closed and place a dark colored wash rage in the sink, you may notice the deposits flowing through the faucet. While you have the aerator removed clean that or replace it, they are cheap.) If all this fails then you will probably have to replace the valve under the sink.


What is a pressure flip?

A pressure flip refers to a sudden change in pressure conditions that causes a rapid shift in a system's state, often seen in fluid dynamics or meteorology. For instance, in weather systems, a pressure flip can occur when high-pressure air masses displace low-pressure systems, leading to dramatic changes in weather patterns. This phenomenon can also apply to engineering contexts, such as in pressure vessels or pipelines, where a rapid change in internal pressure can lead to structural failure or other critical events.


What is the problem in a well pressure tank system after you replaced bladder tank and pressure switch Pressure goes up to 50 drops to 40 then after a minute it falls to 0?

Your pump has a leak and the water in the pressure tank is going back down into your well. The only other possibility is that you have a leaking pipe in/under your house. If that's the case, get it fixed immediately or you will have irreversible mold damage.


What is the Difference between an active earth pressure and passive earth pressure?

When the wall moves away from the backfill, the earth pressure on the wall decreases. This minimum pressure is called active earth pressure. On the other hand if the wall moves towards the backfill, the earth pressure increases. This maximum pressure is called passive earth pressure.

Related Questions

What causes new faucets in the shower to be more sensitive when adjusting water temp than other faucets in the house?

Mixer valve


What causes high water pressure in the first faucet on the water line from where it enters the house. The cold water is under high pressure but other faucets in house are fine.?

Possibly a pressure reducing valve installed after piping for first faucet, which would cause situation describing.


What would the pressure in your kitchen faucet be low if all other sinks in the house are fine?

Most of the newer kitchen faucets have "flow restrictors" to limit water use.


When flushing toilet all other faucets have no pressure?

Low water pressure or cold water main undersized.


What would cause a tub faucet to lose water pressure when the other faucets work?

check for leaks


Water out of the upstairs sinks smell while the other faucets in the house don't?

old pipes in the sink or tub upstairs


What could be the reason for not getting water from the kitchen sink faucets when there is full water pressure on all the other house faucets?

The water valve under the sink is turned off or has gone bad. It is possible that there is a blockage in the faucet itself. I'd start by ensuring that the water valve is turned off, and take the faucet apart and look for anything out of the ordinary.


Your shower faucet drips only when water is turned on in other parts of the house for instance dishwasher This began when you changed the shower head Why is this happening?

Have you got two single faucets or a single lever faucet? It could be a pressure imbalance or it could just need maintenance


Why would you have Lukewarm water in upstairs showertub but have hot water from all other faucets in the house?

Temperature balance shower body needs to be adjusted


How does the weight of the earths crust help to form metamorpic rocks?

Weight causes density, density causes pressure, pressure causes heat. Heat and pressure change rocks into other rocks, which are metamophic.


How do you blow out waterlines in mobile homes?

Just the same as in a house. - detach a faucet or many faucets, at one end of building and blow in air from the other end.


What is the process other than heat that causes metamorphism?

pressure.