0
What else can I help you with?
Under what circumstances would it be advantageous to pattern a component?
It would be advantageous to use a pattern command when you must repeat the same constraint multiple times. An example would be in playgrounds on the platforms where there are multiple holes for rain to go through. In CAD it would be a pain to extrude each hole one by one. The pattern command will make it much faster and efficient.
What is a knockout in a circuit breaker panel?
A knockout is a pre stamped hole in a distribution panel. The metal slug in the pre stamped hole requires knocking or prying to remove it from the panel. Once the slug is removed from the hole, a cable connector is fitted through and secured with a lock nut on the inside of the panel. A wire cable is then threaded through the cable connector and held securely in place by the connectors wire clamp.
How do doors keep your house warm?
They provide a bit of a barrier between the outside and your house, so during winter the cold wind can't just blow straight inside, or it can make the house colder if there would otherwise be no door and hole in the wall at all. During summer, though, in some places doors would definitely help keep your house cooler than if there were a hole in the wall, but not cooler than if there were no door or hole at all.
How do you repair a small puncture hole from a nail in PVC pressure water pipe embedded in cement flooring?
If the hole is clear of the concrete get a little bit of pipe 25mm or an inch and cut it along the length so that you have a ring that opens up. Get some PVC primer and PVC solvent cement . use the primer to clean the outside of the pipe with the hole in it and the inside of the patch. put solvent cement on the pipe around where the patch is going. stretch the ring so it opens up and covers the hole and hold it in place. you can do this with a suitable hose clamp. wait a couple of hours before use. if you can reach the inside of the pipe you can use a similar procedure,
Why is a drill a screw?
To help pull the bit into the surface being drilled and the spiral on the bit gives the material from the hole a place to go and pulls it out of the hole.
What constraint would you use to place a pin inside a hole'?
Tweezer constraint
What constraint would you use to place a pin in a hole?
A clearance fit constraint is commonly used to place a pin in a hole, ensuring a close fit between the two parts while allowing for easy assembly and disassembly. This constraint enables the pin to slide into the hole with minimal interference, preventing any unnecessary movement.
Why did they dig a hole in the movie inside man?
The hole was dug as a place for the "inside man", aka Dalton Russell (Clive Owen) to relieve himself.
Is a black hole known as a singularity?
No, they are not the same. A singularity would be inside a black hole.
Can a black hole turn you inside out?
No, it would tear you apart.
What would happen to a meteoroid inside a black hole?
Gone.
How small would the Earth appear if it were inside a black hole?
If the Earth were inside a black hole, it would appear much smaller due to the extreme gravitational forces bending light.
How does circulation of materials take place in jellyfish?
a jellyfish has a hole in the middle of its body and the tentacles go inside that hole and it gets fertilised
After installing the corner cap and cover pieces you would?
Place a special washer in every other cap hole all the way around the inside of the repair
How much dirt be in a hole 6ft deep by 6ft wide?
A hole according to dictionary.com is a hollow place in a solid body or mass.Since the hole is hollow(empty), there will be no dirt inside of it.
How many astronauts went inside the black hole?
For all scientific reasons, no astronaut had went inside a black hole. It would take many earth years to visit the black hole, so reaching a black hole is impossible.
What would happen if a supernova exploded inside a black hole?
It wouldn't and couldn't
