Gauge factor(GF) orstrain factorof astrain gaugeis the ratio of relative change inelectrical resistanceto themechanical strainε, which is the relative change in length.
To strain is a verb. Strain is also a noun which means "Line of decent". Although it is mainly used as a verb to mean either: "To pull or draw tight" or "to sprain" or "hug" or "strive" or "to pass through a strainer". It has several meanings so it depends on what you mean to say. Hope that helps.
PVC gauge is the thickness of the PVC material: 1 gauge = 1/100 mil = 1/100,000 inch = 25.4/100000 millimetre = 0.254 micrometre
The diameter of the largest workpiece that can be rotated on the spindle without hitting the bed. This is the first of the two numbers used to describe the size of a metal lathe. In the case of the 7x10 or 7x12 lathes, it is 7".http://www.mini-lathe.com/Mini_lathe/Introduction/introduction.htm
The spindle of a lathe is a rotating hollow tube within, and protruding the head stock and to which a chuck, drive plate or facing plate attaches and rotates to enable machining. It is housed within the head stock in bearings and has some gears around it which is driven by other gears which in turn is driven by an electrical motor.
Gauge factor(GF) orstrain factorof astrain gaugeis the ratio of relative change inelectrical resistanceto themechanical strainε, which is the relative change in length.
The ratio of lateral strain to the longitudinal strain is called as poissions ratio
Ferine means wild; untamed. Strain used with ferine means song. So ferine strain is 'wild song'.
presuming you mean the lead screw on a lathe, used when cutting threads on the workpiece, then the screw itself is obviously fixed, but the rotation of it may be able to be changed, depending on the lathe manufacturer.
The word distress mean to subject to great strain or difficulties.
Nothing. Gauge refers to shotgun bore
The gauge length of a specimen refers to the specific length of the material being tested, typically in tensile testing, over which measurements such as elongation and strain are recorded. It is the portion of the specimen that is subjected to stress during the test and is critical for determining mechanical properties like tensile strength and ductility. Accurate measurement of the gauge length is essential for reliable test results and comparisons between different materials.
the centre distance between centre you can turn the component o lathe machine
Its referring to a specific strain of bacteria.
To strain, or verbtensetautenbracepull
Rotors for disc brakes can be machined on the car or taken off and done. A bench mounted brake lathe does it off of the car. The rotor is clamped on the lathe which turn the rotor and a cutting chisel runs over the face to make a smooth surface. Takes out grooves and any warp there may be in the rotor.
Gauge is a noun (a gauge) and a verb (to gauge).