It is halved. coz voltage=current * resistance
A voltage error circuit is called an error amplifier and happens when there are discrepancies between the voltage output and the reference voltage. A current error circuit happens when there is a disruption of flow in an ammeter.
The current in the circuit will be decreased by half. Ohm's law states V=IR so, I=V/R. If R is doubled, then I= V/2R.
In this case current flows from a high voltage to a lower voltage in a circuit.
Voltage attempts to make a current flow, and current will flow if the circuit is complete. It is possible to have voltage without current, but current cannot flow without voltage. The answer is "yes",voltage remains the same as current moves through the circuit.As the voltage remains constant, current increases in the circuit.
It is halved. coz voltage=current * resistance
In a parallel circuit, the total resistance remains the same when the voltage applied is doubled. Each branch in the parallel circuit will experience the same increase in voltage, but their individual resistances will remain constant.
If resistance is doubled in a circuit with constant voltage, Ohm's Law (V=IR) states that current (I) would be halved since the voltage is constant. This is because the relationship between resistance and current is inversely proportional.
If the voltage in a circuit were doubled, the current would also double according to Ohm's Law (I = V/R), assuming the resistance in the circuit remains constant. This is because current is directly proportional to voltage when resistance is held constant.
A voltage error circuit is called an error amplifier and happens when there are discrepancies between the voltage output and the reference voltage. A current error circuit happens when there is a disruption of flow in an ammeter.
The current in the circuit will be decreased by half. Ohm's law states V=IR so, I=V/R. If R is doubled, then I= V/2R.
In this case current flows from a high voltage to a lower voltage in a circuit.
it will cause a Short Circuit
The current leads the voltage by 90degree....
In an electrical circuit, if resistance is doubled, EMF (measured in volts) stays constant, and current is halved.
If the number of receivers (branches) in a circuit is doubled, the overall current of the circuit would also double, assuming that the voltage remains constant. This is because current is divided equally among the branches in a series circuit, so increasing the number of branches would result in each branch carrying less current if the overall current remained the same.
If the voltage is doubled and the resistance is constant, Ohm's Law states that the current will also double. This is because the relationship between voltage, current, and resistance is linear, and increasing the voltage will directly increase the current flow.