A: If you are lucky a fuse blow or a circuit breaker opens up. If not a fire maybe started in the walls where is hard to see and put it out. In the USA the outlets are implemented to be used with a 15 amperes total. By drawing more current continuously the wiring get hot because of the current passing to the load if sustained for too long a fire may start. It is preferable to short out the outlet because that will insure a fuse blow or a circuit breaker open up continuous overload is very dangerous
This is a very technical electrical question that may be difficult to understand without further study. But adding appliances to an outlet is the same as adding resistance in parallel. Adding resistance in parallel, the resistance of the circuit goes down. That is why you get more current flow. By contrast, adding resistance in series increases the resistance of the circuit and therefore reduces current, all else being equal.
If you add a second resistor, the resistance of series circuit will increase.
oppen circuit
It is halved. coz voltage=current * resistance
The circuit becomes a pure resistance circuit where current and voltage are in phase with each others.
This is a very technical electrical question that may be difficult to understand without further study. But adding appliances to an outlet is the same as adding resistance in parallel. Adding resistance in parallel, the resistance of the circuit goes down. That is why you get more current flow. By contrast, adding resistance in series increases the resistance of the circuit and therefore reduces current, all else being equal.
The supply voltage in a parallel circuit remains the same regardless of the number of additional resistors connected. The voltage across each resistor in a parallel circuit is the same as the supply voltage. Adding more resistors in parallel will increase the total current drawn from the supply.
If you add a second resistor, the resistance of series circuit will increase.
The circuit resistance is likely to gradually drop and in such case it will cause the circuit to burn down.
When you add resistance to a circuit, current goes down. Ohm's Law: current = voltage divided by resistance.
Increasing the length of wire in a series circuit increases the overall resistance in the circuit, which reduces the current flowing through the circuit. This results in a decrease in the brightness of any connected bulbs or the speed of any connected motors, as the components receive less energy due to the increased resistance.
It shortens
the circuit is broken.
oppen circuit
😉
When you increase the resistance in a circuit, the current (amps) in the circuit will decrease. This is because Ohm's Law states that current is inversely proportional to resistance, so as resistance increases, current decreases.
What do you mean by a 'parallel delta' circuit -is there such a connection.