In a cold water storage cistern with a capacity of 115 liters, the required distance between the water level and the outlet of the warning pipe should typically be at least 25 mm (1 inch) to prevent overflow and ensure proper drainage. This distance helps maintain an air gap to avoid backflow and contamination. It's important to check local Plumbing codes as requirements may vary.
What is the difference between rated capacity and the nominal capacity
Design capacity is the maximum theoretical output of a system. Normally expressed as a rate Effective capacity is the capacity a firm expects to achieve given current operating constraints. Often lower than design capacity
Your question is unclear. But, if you are asking what the relationship between voltage and the distance between conductors is, then the higher the voltage, the greater the distance must be.
The area of the sheets, the distance between them, and the material between them.
The span
The required distance between ground rods for effective grounding is typically 6 to 8 feet apart.
what is the required distance beteen emergaency exit dorrs for industrial buildings
200 feet
Capacity is the maximum amount that something can contain. Distance is an amount of space between two things.
Understand that there is no relationship between the amount of steering required and the distance you are from the object
That would depend on where it's sited.
This is the approximate time required. The distance considered for the journey is the shortest route chosen between the places. Also traffic rules like one ways and no entries have not been considered.the time required between the above places is 44 hours, 1 minute
This is the approximate time required. The distance considered for the journey is the shortest route chosen between the places. Also traffic rules like one ways and no entries have not been considered.the time required between the above places is 43 hours, 34 minutes
Specific heat capacity is the amount of heat energy required to raise the temperature of a body per unit of mass.
This is the approximate time required. The distance considered for the journey is the shortest route chosen between the places. Also traffic rules like one ways and no entries have not been considered.the time required between the above places is 13 hours, 48 minutes
This will depend on the type of tree and type of cover required.
Since speed is a ratio between distance and the time it took to move that distance, the two required measures are Distanceand Time.