In shortg circuit current is infinitive.
Current = (Voltage across the circuit) divided by (Total resistance of the circuit). The current is the same at every point in the series circuit.
An open circuit has no current ( 0 amperes ).
A circuit that has more than one path for the current to flow is a parallel circuit. The circuit must have two or more paths to be considered parallel. A circuit that has only one current path through multiple components is a series circuit.
Yes In parallel circuit , current entering into the circuit will be divided intodifferent paths ( resistances) . Amount of current flow depends upon the magnitude of resistance applied in the circuit. Total current after passing through the circuit will be the sum of all current through each resistance.
in flat top sampling the electronic circuit required for sampling are less complicated as compared to the one used in natural sampling, at demodulation of the sample it is very difficult to maintain the natural waveform of the natural sampling so flat top sampling can easily be demodulated.
The current in a circuit is reduced to prevent the circuit from over load.
A logic gate is a computer circuit with several inputs but only one output that can be activated by a particular combinations of inputs, a diagram that shows the major gates can be found here.An example would be if you have 2 wires going to an AND gate and only 1 wire has a current (is on, 1) and the other one is 0, then your output would be 0 as you need wire 1 AND wire 2 to have a current, for the output to be 1, on.A sampling gate, on the other hand is a circuit that produces an output only when first activated by a preliminary pulse. So if you have a current going through a wire and through a sampling gate, your output would be 0, unless you program the sampling gate to let the current through.I'm sorry if this is a slightly plain answer, but if you would like more reading, then go to the Wikipedia.
A circuit diagram of a sampling system typically consists of a signal source, a sampler (like a switch), a hold circuit (to retain the sampled value), and an analog-to-digital converter to convert the sampled signal into a digital format. The switch opens and closes based on a clock signal, allowing the signal to be sampled at discrete time intervals.
In shortg circuit current is infinitive.
Current = (Voltage across the circuit) divided by (Total resistance of the circuit). The current is the same at every point in the series circuit.
The current flowing in an electrical circuit.
If the track of the current is broken in a series circuit, the circuit will be interrupted and no current will flow. The components in the circuit will not receive any power and will not function until the circuit is repaired.
In a circuit , current is inversely proportional to the resistance.
Electricity flows in a circuit to generate a current.
current mirror circuit produce more stability as compared to biased circuit.
Yes, in a closed circuit, the current is constant and flows continuously through the circuit.