i) leakage flux is those flux which goes through the air and linkage flux is those flux whose go through the cell. ii)leakage flux is the loss at flux but linkage flu is warning flux. iii)leakage flux is cause of eddy current loss and linkage flux is case of copper loss.
light speeeed mofos
Basically useful fluke is the flux that flows with in the magnetic circuit of an armature. That is why when there is an air gap the flux enters the armature which makes it useful flux! Hope that answers your question!
A generator, in general.
Flux is produced in both AC and DC systems, but the nature of the flux differs. In DC circuits, the magnetic flux is constant, as the current flows in one direction. In AC circuits, the magnetic flux changes direction and magnitude periodically, resulting in a time-varying magnetic field. Thus, while both types of current can produce flux, AC generates a dynamic flux due to its oscillating nature.
i) leakage flux is those flux which goes through the air and linkage flux is those flux whose go through the cell. ii)leakage flux is the loss at flux but linkage flu is warning flux. iii)leakage flux is cause of eddy current loss and linkage flux is case of copper loss.
racipe of the glaze for sanitary ware
Peter Glaze is 5' 5".
Billy Glaze was born in 1944.
Confectioner's Glaze, which is also known as resinous glaze, pure food glaze, natural glaze, and pharmacutical glaze, is an alcohol-based solution. When it is created, dried flakes of shellac (which is made from the secretions of female lac bugs) are re-dissolved in denatured alcohol.
The Ratio of the total flux ( flux in iron path) to the useful flux (flux in air gap)
Haley ray invented glaze on febuary 8,1888.
The duration of Honey Glaze is 1.42 hours.
First you would paint the vase with a glaze. Then you must put it in a kiln for a specified amount of time in order to set the glaze.
Ceramic crawling is a glaze defect that occurs when the glaze pulls away from the surface of the ceramic during firing, leaving patches where the glaze did not adhere. This can happen due to poor glaze application, dust or oil contamination on the surface, or incompatible materials.
when a current flow through the coil then flux produced around the coil . if the flux linked same produced coil only then the flux is said to be leakage flux. flux produced by one coil ,but linked with another coil then the flu is said to be mutual flux.
when a current flow through the coil then flux produced around the coil . if the flux linked same produced coil only then the flux is said to be leakage flux. flux produced by one coil ,but linked with another coil then the flu is said to be mutual flux.