answersLogoWhite

0

Back-to-back housing refers to a type of residential construction where two houses share a common wall at the rear, with no space between them. This design typically maximizes land use and is often seen in urban areas where space is limited. Each house has its own front and back entrance, but the rear gardens or yards are adjacent without a gap. This type of housing can be cost-effective and offers a compact living solution.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

How do you replace a headlight on a 1999 Nissan Quest?

you mean the bulb? It's in the housing and comes out by opening the hood, reaching behind the housing and loosening the fixture from the back of the housing. Bulb pops into the fixture, then put it back in the housing. Usually comes out with half a turn.


What are the parts of turbocharger?

The parts of a turbo going from front to back are: Compressor housing, inside the housing is the compressor and that compresses the air. the compressor housing is attached to the main bearing housing/core, and on the backside is the exhaust turbine inside the exhaust housing.


Where is the thermostat located on a 2000 Chevy Blazer?

GM thermostats on V8 engines are quite easy to find. Follow the top radiator hose back to the engine. That hose connects to a housing and the housing bolts to the engine. Remove the hose then remove the housing and the thermostat should be RIGHT THERE. Before putting the housing back in place make sure the intake manifold and thermostat housing are both thoroughly cleaned before you put the gasket and thermostat back in place.


Where is the temperature sensor located on your 1996 Dodge Ram 1500 with the 5.2 Liter motor?

Top front of motor, next to the thermostat housing, under the back of the alternator.Top front of motor, next to the thermostat housing, under the back of the alternator.


Where is rear axle housing Ford Ranger 1999?

Between the 2 back wheels , in the center (differential housing) where the drive gears are


How do you remove back housing light cover on Chevy s10?

Open tail gate, remove the two small screws going in from the side, wiggle tail light housing straight back and out.


Where is thermostate housing on Chevy 350?

Follow the top radiator hose back to the engine. You'll see a housing that's held in place with two bolts... that's the thermostat housing.


Where is Fuse for CD changer on 98 BMW 528?

On the back of the housing


Where is the pcv valve on a 2002 Chevrolet tracker?

The 2002 Chevrolet PCV valve is located on the outside of the air intake housing. The valve will be on the back of the housing.


Where is the oxygen sensor on a 1988 Toyota?

The 1988 Toyota oxygen sensor is located on the air cleaner housing. You will find the sensor, on the back side of the housing.


Where is the EGR valve on a 1991 Geo Metro?

The 1991 Geo Metro EGR valve can be located on the air cleaner housing. The valve will be on the back of the housing.


Where is the PCV valve located on a 2007 Dodge Durango 4.7?

It is in the back side of the oil filler housing. Look just behind the oil filler cap.It is in the back side of the oil filler housing. Look just behind the oil filler cap.