An inductive filter is an electrical component that uses inductors to filter out unwanted frequencies from a signal, allowing desired frequencies to pass through. It operates on the principle that inductors resist changes in current, effectively attenuating high-frequency noise while permitting lower-frequency signals to flow. Inductive filters are commonly used in power supplies and audio systems to improve signal quality and reduce electromagnetic interference.
By using a matching network, or filter (active or passive).
inductive appeal
The question makes no sense. It asks why a pure inductive load is used ... instead of a pure inductive load. Please restate the question.
The actual energy consumed in load is inductive load
non- inductive load is without motor and transformer loads are non-inductive load, purely resistive are capacitive loads phase angle is unity are leading PF A non-inductive load is a load whose current does not change instantaneously.
An inductive filter is in fact an LC circuit in which an inductor is connected in series with the capacitor. This arrangement is also known as a low-pass filter. http://www.answers.com/topic/inductive-filter
By using a matching network, or filter (active or passive).
inductive appeal
Type your answer here... empirical
Inductive is an adjective.
Examples of inductive reasoning are numerous. Lots of IQ or intelligence tests are based on inductive reasoning. Patterns and inductive reasoning are closely related. Find here a couple of good examples of inductive reasoning that will really help you understand inductive reasoning But what is inductive reasoning? Inductive reasoning is making conclusions based on patterns you observe.
The symbol for inductive reactance is XL.
Inductive automation was created in 2003.
Syllogism, logic (deductive or inductive).Syllogism, logic (deductive or inductive).Syllogism, logic (deductive or inductive).Syllogism, logic (deductive or inductive).
Inductive automation's motto is 'Breakthrough to Possible'.
inductive-reasoning
Where you are measuring. A simple filter will be two elements - a capacitor or inductor and a resistor. A capacitor will tend to "trap" low frequencies. In the case of a lowpass filter made of a capacitor and resistor, the output voltage will be measured across the capacitor. Inductors are the opposite, so the output would be across the resistor.