Unlike a static condenser (capacitor bank), the value of reactive power from a synchronous condenser can be continuously adjusted. A synchronous condenser also has other advantages over static condensers such as: - not being affecting by harmonics (some harmonics can even be absorbed by a synch condenser) - producing no switching transients
The reason why it is called a barometric condenser is because it makes contact and it is a long vertical pipe into which it condensates and cools the liquid flow to accomplish the removal of pressure. It is also stated that when the pump is used the system is called a low level barometric condenser.
condenser approach is heat transfer the water to gas of condenser efficiency is good less then below (2 F) the system is working good.
There are several roles of a condenser system depending on what is using it. In a microscope, a condenser system helps gather and focus light for a clearer view. In an air conditioner a condenser system cools heated gas so it can be used again.
To keep the Liebig condenser cool so it can condense the vapour
High hotwell level will get the cooling water tubes of condenser submerged in the condensate hence cooling efect will be reduced consequentaly vacuum will drop. Low hotwell level will lead to low suction pressure of Condensate Extraction Pump hence it may lead to cavitation.
hotwell
A hotwell in a thermal power plant is a reservoir or tank that collects condensate from the turbine exhaust steam and other feedwater sources. It helps in recovering and recycling the steam condensate to maintain efficient water circulation in the power plant's boiler system. The hotwell also serves as a storage tank to supply feedwater to the boiler as needed.
Dear Freind, If you are talking about hotwell in power plant application, then it is always recommended to use displacer or Radar type level transmitter. DP type LT is not recommended since it could malfunction in vacuume condition.
If you mean the condenser to a central A/C system, it is usually located outside the house. The condenser part of the system is responsible for discarding the heat that has been "collected" from the inside the house. It is the evaporator that is inside.
Assuming you mean condenser, in an automobile ac system the condenser is used to condense vapor into liquid.
Liebig condenser, Vigreaux column, Snyder column, West condenser, Allihn condenser, Graham condenser, Dimroth condenser, Friedrichs condenser. There are no shortage of these!
Which condenser are you asking about? There are a couple things that are called a condenser.
well the surface of Jupiter out door and in door is accent hotwell the surface of Jupiter out door and in door is accent hot
Condenser
Condenser back pressure refers to the pressure at which the refrigerant exits the condenser in a cooling system. It is a critical parameter in determining the efficiency of the system and ensuring that the refrigerant is properly condensed back into a liquid state for optimal performance. A high condenser back pressure can indicate issues with the system, such as poor heat transfer or restrictions in the flow of refrigerant.
Drain the cooling system.Remove the radiator.Recover the refrigerant.Remove the receiver dryer.Remove the condenser inlet hose bolt.Remove the condenser inlet hose.Remove the condenser outlet hose bolt.Remove the condenser outlet hose.Remove the condenser from mounts on the radiator.Remove the condenser...........................