0
What else can I help you with?
What is step up transformer?
To transmit a lot of electrical power, you either need a high voltage or a high current. But a higher current means your cables got hotter and you lose a lot of energy so is better to use higher voltage. To increase the voltage, we need to use a step up transformers. Step up transformers are transformers which has ability to increase the voltage and they have more turns on the secondary coil on the primary coil.
How a bucking voltage acts?
bucking voltage is a voltage which is of opposite polarity to the voltage it acts .
What is voltage transformation ratio?
ratio of secondry voltage to primary voltage is called voltage transformation ratio
What is the voltage that supplies a motor starter called?
In the electrical trade it is called control voltage. This voltage can be any voltage. In North America the common control voltage is 120 volts.
How do we adjust the voltage of a shunt generator?
The voltage is adjusted with a potentiometer that adjusts the field voltage through the voltage regulator.
What is the reason for ferranti effect?
Ferranti Effect causes the receiving end voltage to be more than the sending end voltage. It occurs mainly in long transmission lines when they are lightly loaded. In this condition, the inductance of the lines becomes more resulting in increased receiving end voltage.
What burns your spark plug coil?
excessive voltage usually. can be caused by a voltage spike at the alternator, a computer sending too much voltage, or poor wiring
How do you define voltage regulator?
A voltage regulator is a part of the engine that keeps the vehicle from sending too much electricity through the engine from the battery.
Why the sending end voltage is less than receiving end voltage in case of load with leading power factor?
The voltage is attenuated by the resistance in the media used for transmission. This is regardless of the power factor.
What is the voltage regulation of medium transmission line?
Voltage regulation is just the percentage change in voltage at the receiving/sending end of the transmission line from no load to full load. It is given by ((Vnl-Vfl)/(Vnl)) X 100%. Typically Voltage at receiving end is known to us and for the sending end Vnl is given by Vs/A. Where A is given by the ABCD parameters of the transmission line and Vs = AVr + BIr.
How do you reset the computer on 99 gm 3.8L?
need to reset obc after replacing water pump and temp sending unit, had battery disconected during replacment , purged air out cooling system, sending unit sending correct voltage.
What is the coil pack for 2000 dodge stratus?
high voltage sending unit that sits atop each sparkplug
What is a short to voltage in an automobile?
A short to voltage is when a wire that should not have battery voltage has battery voltage. This would happen if a wire had rubbed through another wire. The other cause would be an electrical component failing and sending voltage down a wire that it shouldn't. NOTE: Shorts to voltage are very uncommon. I specialize in electrical automotive repair, and I can not even recall one time I have seen a short to voltage.
Why won't a vehicle turnover?
Check the starter and the solenoid. Make sure that the cables from the battery to the starter are tight and are sending voltage.
What causes code p0463 on a '98 jeep grand cherokee's?
fuel level sending unit voltage is too high
How does a multimeter read volts?
A multimeter reads volts by measuring the electrical potential difference between two points in a circuit. It does this by sending a small known current through the circuit and measuring the voltage drop that occurs. The multimeter then displays this voltage drop as the voltage value on its screen.
What charges the battery while running on an American ironhorse Texas chopper?
An AC generator sending power to a rectifier which converts it to DC voltage.
