0
What else can I help you with?
Should the ohmmeter be connected to the circuit while the power is being applied or only when the circuit is turned off?
Turn off the supply before using the ohmmeter,it will damaged your ohmmeter when supply is present.
Is a ohmmeter a pressure gauge?
No. An Ohmmeter measures electrical resistance to the flow of current.
Is an ohmmeter connected in series or parallel?
You almost NEVER do. 1) The circuit should be off and/or disconnected when using an ohmmeter. 2) It should be in parallel with the component as far as the rest of the circuit is concerned, but alone in series with the device its measuring.
When using an ohmmeter to check the continuity of generator field coil the field coil should?
Read less than 1 ohm
How do you identify the em iter and collector by ohmmeter test?
To identify the emitter and collector in a bipolar junction transistor (BJT) using an ohmmeter test, first ensure the transistor is not connected to any circuit. Set the ohmmeter to the diode test mode, and connect the positive lead to the base and the negative lead to one of the outer terminals; if it shows a forward bias (low resistance), that terminal is the collector. Repeat the process with the negative lead on the base and the positive lead on the other outer terminal; if it shows a forward bias, that terminal is the emitter, confirming the configuration of the BJT.
What is the main rule to be followed when using an ohmmeter?
The main rule to be followed when using an ohmmeter is to have the circuit under test de energized from the power source.
What are two familiar mistakes when using an ohmmeter and a voltmeter?
Voltmeter connect in parallel with the circuit setting on voltmeter highest range first then to lower range. Ohmmeter we need to use the ohmmeter meter setting connect across the resistor
Should the ohmmeter be connected to the circuit while the power is being applied or only when the circuit is turned off?
Turn off the supply before using the ohmmeter,it will damaged your ohmmeter when supply is present.
How the resistance is measure?
Using an ohmmeter, Wheatstone bridge, etc.
What precuation must be taken when using an ohmmeter?
Be certain the circuit is de-energized and discharged before connecting an ohmmeter.Do not apply power to a circuit while measuring resistance.When you are finished using an ohmmeter, switch it to the OFF position if one is provided and remove the leads from the meter.Always adjust the ohmmeter for 0 (or ∞ in shunt ohmmeter) after you change ranges before making the resistance measurement.
When using an ohmmeter to check the resistance of a compressor's windings what scale would you use?
the lowest
How could unmarked diodes have its cathode leads identified using an ohmmeter?
Assuming the red lead of the ohmmeter is more positive than the black lead, then checking the impedance of the diode with the ohmmeter, in both directions, will identify the cathode as the black lead when the measured impedance is low. This, however, will only work if the voltage developed by the ohmmeter is greater than the forward bias voltage of the diode, typically 0.7 volts.
Can you measure a vacuum tube using ohmmeter?
Maybe, but not sure info would be useful. You can use ohmmeter to check that a tube's filament is intact. Broken/burned-out filament is most likely reason for dead tube.
What an ohmmeter measures?
resistance to current flowAn ohmmeter meassures resistance
Is a ohmmeter a pressure gauge?
No. An Ohmmeter measures electrical resistance to the flow of current.
How do you convert galvanometer to ohmmeter?
Ohms are the unit of measurement for resistance, so an ohmmeter is a device that measures electrical resistance. A galvanometer measures the current flowing through the resistance, so the two are related. To convert a galvanometer into an ohmmeter, one needs an external battery.
What is the configuration of the ohmmeter?
An ohmmeter is connected in parallel to a resistor. Be sure that there is no power in the circuit when testing.
