No do to the concrete settling the concrete on top would split
By putting a thin layer of new concrete on top.
The term slump used in concrete means the thickness or thinness of the concrete. The slump is measured by filling a 12" cylinder up with concrete, then flipping it over and pulling the cylinder up. The distance the concrete "slumps" down from the top of the cylinder is the slump for that concrete. For example, if the concrete falls 6" from the top of the cylinder, that concrete is on a 6" slump.
The top layer of concrete is called the structural coat. It directly receives the most load which must then be transferred to lower layers.
You can. You start by applying moisture barrier to the concrete--flooring stores have it--then gluing the hardwood to the concrete.
The best method for preparing and using post hole concrete mix to securely set fence posts in place is to follow these steps: Dig a hole that is at least one-third the length of the post and wider at the bottom than the top. Place the post in the hole and ensure it is level and plumb. Mix the concrete according to the instructions on the bag. Pour the concrete into the hole around the post, filling it to ground level. Use a trowel to smooth the surface of the concrete and slope it away from the post to prevent water pooling. Allow the concrete to cure for the recommended time before attaching the fence panels. Following these steps will help ensure that your fence posts are securely set in place.
No do to the concrete settling the concrete on top would split
The purpose of the hole in a concrete pier block is to allow for easy installation of a metal anchor or post. This hole helps secure the structure built on top of the pier block, increasing its stability by providing a strong connection between the block and the structure.
"I climbed to the top of the fence, then jumped down, ripping my jeans."
By putting a thin layer of new concrete on top.
One of the top companies is Diamond B fence. The have locations across the state and have a solid reputation.
The Dingo Fence
pour more concrete over the top and smooth it out
Before the oversite concrete is laid it is usual to blind the top surface of the hardcore. The purpose of this is to prevent the wet concrete running down between the lumps of broken brick or stone, as this would make it easier for water to seep up through the hardcore and would be wasteful of concrete. To blind, or seal, the top surface of the hardcore a thin layer of very dry coarse concrete can be spread over it, or a thin layer of coarse clinker or ash can be used. This blinding layer, or coat, will be about 50 mm thick, and on it the site concrete is spread and finished with a true level top surface.
Yes, you can install pavers on top of concrete by using a sand bed or mortar to secure them in place.
To prevent your dog from jumping over the fence, you can consider increasing the height of the fence, installing a barrier on top of the fence, providing enough exercise and mental stimulation for your dog, and training your dog to not jump over the fence.
To install pavers on top of concrete, you need to clean the concrete surface, apply a layer of sand, place the pavers on top, and secure them with edging. Fill the gaps with sand and compact the pavers for stability.