445 amps. For example Mulberry AAAC cable.
First determine the amperage of the circuit . e. g 15 amp or 20 amp ( typical household circuit ratings) the gauge is 14 and 12 respectively. The lower the gauge number the higher the current handling capability.
starting current of 315 kw motor in start delta 2.5 time for single sec. if your cable lingth 130 meter u can use 150mm2 (3 cable per phase) 150mm2 single cable current 292 Amp voltage drop 0.28/meters so u can use breaker 1000 Amp and set Im time (for starting current) setting avalible in breaker.
Everything Depends on the voltage supply ...... Current flow (Amp) = Watt / Voltage the Current flow will be 1 amp if voltage is 1 V the Current flow will be 0.5 amp if voltage is 2 V the Current flow will be 0.25 amp if voltage is 4 V and so on.......
The unit of current is the ampere (A), or amp for short. A thousandth of an amp is a milliamp (mA). One amp is equal to one coulomb of charge per second.
You can measure the electrical current with an amp meter. Amperage measures the current flow.
2 AWG Aluminum.
2 AWG Aluminum.
25mm cable
For Service Entrance Cable 600 kcmill (Thousands of circular mils).
Yes, the larger cable can carry more load (current) than the other cable.
The recommended cable size for a 200 amp service entrance is typically 2/0 AWG copper or 4/0 AWG aluminum.
Yes, the larger cable can carry more load (current) than the other cable.
The recommended cable size for a 100 amp electrical circuit is typically 3 AWG copper or 1/0 AWG aluminum.
For a 100 amp service, a minimum of 2-gauge copper or 1/0 aluminum entrance cable should be used.
The recommended size for a 100 amp service entrance cable is typically 2 AWG copper or 1/0 AWG aluminum.
For a 100 amp sub panel, you would typically need a 2-2-2-4 aluminum SER cable. This cable consists of three insulated conductors (two hot and one neutral) and one bare ground wire. It is important to always consult your local electrical code and a qualified electrician to ensure you have the correct size and type of cable for your specific installation.
For a 200 amp service, you would typically need a service cable with a minimum size of 2/0 AWG copper or 4/0 AWG aluminum to safely handle the current. It's important to check local building codes and consult with a licensed electrician to ensure compliance and safety.