Transwitch unit is a flameproof(FLP) wheel mounted transformer used in underground coal mines
with inbuilt breaker on primary side and a protection chamber with circuit breaker on secondary side for overload and earth leakage provision. It can be moved easily from time to time as working face on mine advances.
"flame proof apparatus" means an apparatus that can withstand without injury any explosion of the inflammable gas that may occur within it and can prevent the transmission of flame such as will ignite the inflammable gas which may be present in the surrounding atmosphere.
The usage of transformer is to produce electricity from a main electric unit
ohms is the unit of resistance while volts is the unit of voltage
A phase difference between two periodic signals is the time difference between two corresponding points on each signal. This time difference is usually measured in degrees or radians, but can be given as a unit of time as well.
The unit for electric potential difference is the volt (V).
20 degree difference
Nothing
No difference. A unit of stock is called a share.
There is no difference between a unit plan and a scheme of wok. thank u. By highkult
There is no difference.
UniT transformer are step up transformer which is connected to generating house & step up voltage from 11/15kV votlage to 220/400kV voltage level as requirement or line design parameter. It is just like transformer but connected to unit of the generating house that's why we called it unit transformers.
The usage of transformer is to produce electricity from a main electric unit
Transformer does not convert MVA to KV. MVA is unit of power, where as KV is unit of Voltage. Transformer converts voltgae. Step up or Step down.
1
A meter is a unit of length; a milliliter is a unit of volume.
The formula unit is the representation of a molecule.
A transformer in an AC unit works by converting the voltage of the electricity from the power source to a level that is suitable for the unit to operate. This allows the AC unit to function properly and efficiently.
Check that the input and output voltages are as required. Check that the transformer is big enough for the current required for the unit you have.