120/240 volts at 60 cycles per second ac.
It is supplied as a single phase service, split 120V-0-120V.
One hot leg is 120 volts, a second hot leg 120 volts but running at 180 degrees out of phase from the first leg, and a neutral.
Every 120 volt outlet in your home carries one leg of 120 volts plus the neutral.
If the outlet has a ground, this is for safety in case there is a fault like a short of a hot leg to the internal frame or the outer casing of the appliance, which should always be connected to the ground. If such a fault occurs, the ground wire takes a very high current which causes the circuit breaker to trip or a fuse to blow.
An appliance such as a clothes dryer in your home, that uses 240 volts, is using both hot legs. Because they are 180 degrees out of phase from each other, the combined voltage is 240 volts.
For more information see the answer to the Related Question shown below.
Electrical voltage can be changed by a transformer.
If you are referring to domestic electrical outlets, most regions use either 110 - 120 volts or 230 - 240 volts.
Theoretically there is no limit to the voltage of an electrical current.
Voltage is a measure of electrical potential. I understood voltage best when my first semester Electronics professor told the class that voltage is to an electrical circuit as water pressure is to a plumbing "circuit".
The Volt
The standard voltage in Brazil for electrical appliances is 127 volts.
The voltage typically found in a standard electrical outlet is 120 volts.
The standard voltage for a typical electrical outlet is 120 volts, and the standard amperage is 15 amps.
The voltage specification for a US electrical outlet is 120 volts, and the frequency specification is 60 Hz.
The standard voltage and frequency used in most residential electrical systems is 220 volts at a frequency of 60 hertz.
Yes. In the United States, standard household voltage is 120VAC @ 60Hz. If properly installed, you can also run standard devices at 220 or 240 volts AC in the US.
In an electrical circuit, the wire connected to the positive terminal of the voltage source carries the voltage. This wire is usually indicated by the color red in standard wiring practices.
Zero Voltage switching is a standard used to describe electrical appliances which turn on or off only when the output voltage is Zero.
No. Unfortunately every country has different electrical standards. In North America the electrical standard is of 110-120 volts at a frequency of 60 Hz
The standard household AC electrical power mains voltage in Greece is 230 volts, with a frequency of 50 Hz.
The standard voltage for residential electrical systems in the United States is 120 volts for most outlets and 240 volts for larger appliances like stoves and dryers.
The highest voltage for lighting in a home in the US is typically 120 volts. This is the standard voltage used for residential lighting fixtures.