inductive reactance= XL= 2*pi*.1*60=12pi ohm
Use the formula: reactance equals 2.pi times frequency times inductance.
The current through a pure, or ideal, inductor having zero resistance, would lag the voltage with a phase angle of 90 degrees. The inductive reactance of a 1 Henry inductor at 60 hz is about 380 ohms. XL = 2 * pi * f * L so 200 volts at 380 ohms is about 0.53 amps and the power drawn, using the basic Power equation: power = volts * amps, would be about 105 vars. Var is the correct term for volts times amps, or volt-amp-reactive, where we consider the phase angle to be 90 degrees.
Resistance is like frictional force. It opposes flow of electricity. So this will consume some electricity in the form of heat. Measured (in Ohm) Inductance (in Henry) nd capacitance (in farad) stores energy in their electromagnetic nd electrostatic fields respectively. They don't consume any power. But in real scenarios due to the element's internal resistances used in design they usually have a drop. But these two have important spot in engineering. Both of them effects the powerfactor in the circuits.
Henry Bessemer
This is the symbol for a microhenry, or one-millionth of a henry. The henry is the SI unit for inductance.
The inductive reactance of a 15 Henry inductor at 60 Hz is about 5.7 KOhms. (2 pi f l)
Inductive reactence is given by Xl = 2*pi*F*L = 2*3.14*60*9 = 3.912 K Ohm
Inductive- Specific to General.
Use the formula: reactance equals 2.pi times frequency times inductance.
The current through a pure, or ideal, inductor having zero resistance, would lag the voltage with a phase angle of 90 degrees. The inductive reactance of a 1 Henry inductor at 60 hz is about 380 ohms. XL = 2 * pi * f * L so 200 volts at 380 ohms is about 0.53 amps and the power drawn, using the basic Power equation: power = volts * amps, would be about 105 vars. Var is the correct term for volts times amps, or volt-amp-reactive, where we consider the phase angle to be 90 degrees.
Resistance is like frictional force. It opposes flow of electricity. So this will consume some electricity in the form of heat. Measured (in Ohm) Inductance (in Henry) nd capacitance (in farad) stores energy in their electromagnetic nd electrostatic fields respectively. They don't consume any power. But in real scenarios due to the element's internal resistances used in design they usually have a drop. But these two have important spot in engineering. Both of them effects the powerfactor in the circuits.
microsoft
Inductors can be measured in all three of the above:When an the value of an inductor is given in henrys you are being given its "capacity" to store energy in a magnetic field.Because the inductor is not made of a perfect conductor (one without resistance) it will inevitably has some associated resistance. This is the value that is being referred to if the value of ohms is given.If an inductor is part of an AC (alternating current) circuit it will have a changing "resistance" (resistance as seen by the source) that is directly related to the frequency of the circuit. This is where the reactance value would be given. It equation is given as: 2*pi*f*L. Where f is frequency in hertz and L is the inductance given in henrys..
It can determine that the constellation has a certsain amount of connected stars
no, Louis Jolliet and Jaques Marquette did.
No, they are a nonpartisan source for healthcare information.
Henry P. Dunster has written: 'How to make the land pay, or, Profitable industries connected with the land and suitable to all occupations, large or small'