answersLogoWhite

0

2.5 times of design load

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is allowable structural capacity of pile in pile load test?

allowable structural capacity


How can check the capacity of pile foundation?

This can be done by physically loading the pile by a test load which is 1.5 times the design load on the pile, or by other indirect methods like dynamic test methods. D mohan


What is ultimate load test to bored pile?

The question itself is not correct.It should be what is the ultimate load carrying capacity of bored pile?Ans: Ultimate load carrying capacity of pile could be determined be conducting load test.Ultimate load:The load at which the pile continuously settle.orthe load at which settlement of the pile reaches 10 percent of its diameter


What is the is code for pile load test?

IS 2911 part 4


When using a carbon pile to load test a battery what occurs as you turn the control knob clockwise?

You will increase the amp load on the battery.


What is the definition for marshall mix design?

The mix design (wetmix) determines the optimum bitumen content.The Marshall stability and flow test provides the performance prediction measure for the Marshall mix design method. The stability portion of the test measures the maximum load supported by the test specimen at a loading rate of 50.8 mm/minute. Load is applied to the specimen till failure, and the maximum load is designated as stability. During the loading, an attached dial gauge measures the specimen's plastic flow (deformation) due to the loading. The flow value is recorded in 0.25 mm (0.01 inch) increments at the same time when the maximum load is recorded.


Why does the tensile test curve decrease after a maximum load is obtained?

because the cross-sectional area decreases as the test progresses. to keep the pressure constant, the weight must decrease. (pressure is force divided by area)


How do you test the Cold Crushing Strength?

Cold crushing strength can be tested using a universal testing machine to apply a compressive load to the test specimen until failure occurs. The test specimen should be of a specific dimension and prepared according to relevant standards. The maximum load sustained by the specimen before failure is recorded as the Cold Crushing Strength.


What is the initial load in Rockwell hardness test?

The initial load in Rockwell hardness test is 10KGf.


Why should dc series motor can be operated for no load and light load?

dc motors can be operated at no load as well as at load condition.But by using the swin burns test the efficiency can be calculated at no load which is more benficial than load test.At industries this swin burns test is used because for load test we have to give separate supply for the load to run.In no load test that power is saved.


How do you load test a Harley Davidson motorcycle battery?

You can take it to a battery place and they can test it under a load.


In weight test what is the difference between a static test load and a dynamic test load?

A static test load is applied gradually and held constant to measure the structure's deformation and ultimate load-carrying capacity. On the other hand, a dynamic test load is applied rapidly and repeatedly to simulate real-life conditions and assess the structure's response to dynamic loads such as wind or seismic activity.