answersLogoWhite

0

What else can I help you with?

Related Questions

What is isochronous and droop in generator parralel operation?

isochronous means generator zero drop during parale operationdroop means the generator at 100% load the frequency is50 HZand at no load have more tahn 5oHz eg.. generator set at 4% droop it means at no load the frequency is 104% x 50Hz.


IEEE 1394 uses meaning that data is transferred continuously without breaks?

isochronous


What is the caused of unbalance of current during parallel running of two generator?

That depends on if the two machines are of equal KVA rating and also what type of Generator Control (Isochronous or Droop) each of the machines uses.


When was Isochronous - band - created?

Isochronous - band - was created in 2006.


What are isochronous?

Isochronous literally means "to occur at the same time or at equal time interval.


What are two ways that a generator can be cooled?

Air and hydrogen gas can be pumped through


Explain 8253 microprocessor with wave forms?

There are 6 modes of operation of 8253 as follows: MODE 1:PROGRAMMABLE ONE SHOT MODE 0:INTERRUPT ON TERMINAL COUNT MODE 2:RATE GENERATER/PULSE GENERATOR MODE 3:SQUARW WAVE GENERATOR MODE 4:SOFTWARE TRIGGERED STROBE MODE 5:HARDWARE TRIGGERED STROBE There is very long discriptions on each mode wih waveforms.


What is isochronous satellites?

An isochronous satellite is one that orbits the earth in one day. So it orbits the earth as the same speed as the earth rotates. Most satellites that are isochronous are infact geostationary satellites as they also stay in the same position above the earth. However these satellites occupy a very specific orbit above the equator. It is possible to have isochronous satellites that aren't geostationary however getting them to remain in orbit would prove difficult.


How to turn a generator to standby?

When turning a generator to a standby operations mode, there is often a switch on the generator. By turning the switch on and off, you should be able to use the generator should the power turn off and resume electricity which may have been interrupted


What happens if too much load is put on a generator in 240v mode?

If too much load is placed on a generator operating in 240V mode, it can lead to overheating and potential damage to the generator's internal components. This overload may cause the generator to stall or trip its circuit breakers to protect itself from damage. Continuous overloading can reduce the generator's lifespan and impair its performance. It's essential to ensure the connected load does not exceed the generator's rated capacity to maintain safe and efficient operation.


What is generator's root meaning?

to bring forth life


A governor with 0 percent droop What it should call ed?

An Isochronous governor