ping -n 8 destination
the network path to a destination
in this test their is a no load on dc shunt motor so it is an indirect test
First, make sure you have #!/usr/bin/perl at the top. Then, click enter, and type: print "Hello, World!"; After that, save it as name.pl (replace name with whatever you want to name it) and you are all done! Test it out on a web server that supports perl or the perl command line.
For ERW MS OR HR TUBE/PIPE below are the important test which has to be done, in order to conform the following standard and stablished Qc guidelines , (a) Tensile Test (b) Drift Expanding Test (c) Flattening test (d) Hardness test of material (e) If the material is soft , Cupping test can be done. (f) Bending Test (g) Eddy Current Test (On-line Test) (h) Zinc Adherence test (If GI pipe)
A mock test does not carry marks. It prepares one to be ready for an actual test.
For a Microsoft Windows computer: ping -n 9 For a Linux computer: ping -c 9
To test whether your computer has connectivity to the network, you can use the ping command followed by a known IP address or domain name. For example, you can type ping 8.8.8.8 (which is a Google DNS server) or ping www.google.com in the command prompt. This command sends packets to the specified address and displays the response time, indicating whether the network connection is functioning properly. If you receive replies, your computer is connected to the network; if not, there may be connectivity issues.
Ping
The command used to test the IPv4 protocol stack is ping. This command sends Internet Control Message Protocol (ICMP) echo request packets to a specified IP address and waits for a response, helping to diagnose network connectivity issues. By using ping, users can determine if a host is reachable over the network and measure the round-trip time for messages sent.
PING is what you need to use . Ping 127.0.0.1
The ping command. Traceroute is also useful, but I would start by using the ping command.The ping command. Traceroute is also useful, but I would start by using the ping command.The ping command. Traceroute is also useful, but I would start by using the ping command.The ping command. Traceroute is also useful, but I would start by using the ping command.
The ping command.
ping
ping
ping 127.0.0.1 CompTIA A+ page 972
ping 127.0.0.1 CompTIA A+ page 972
Use the PING (and current IP address) command to execute a loopback test on a NIC