strobe is enable input in a digital IC...if its made active high...it will be enabled..some IC strobe is active low.. Its function is to enable the operation of the IC..or gate or Mux...
The strobe pin on the LM311 is used to disable the output, so that multiple 311's can be ganged together, with only one being turned on at a time. It is also used to adjust the balance of the device.
pin tetel
r2j10160
musical 3 pin IC UM66 and a popularly known Transistor BC548b
Pin 8 is called Strobe pin. It is used for Phase compensation and Gain control to optimize frequency response. For this a capacitor(usually 47 pF) is connected between pin 8 and pin1
strobe is enable input in a digital IC...if its made active high...it will be enabled..some IC strobe is active low.. Its function is to enable the operation of the IC..or gate or Mux...
The change in voltage from two indepentant sources activates this component. perhaps this is useful.
It is a data selector. There are 16 digital input lines, 4-bit decoder, strobe and output pin. So you put a 4-bit binary number from 0-15 into ABCD bits and the corresponding input value is found on output at the strobe time.
The 3130 is an all MOS design whereas the 3140 is MOS input and bipolar output giving it a much better output drive. The 3140 is preferred in most applications.
The strobe pin on the LM311 is used to disable the output, so that multiple 311's can be ganged together, with only one being turned on at a time. It is also used to adjust the balance of the device.
The 8085 is a 40 pin ic because Intel designed it that way.
What enable1&enable2 in pin l293d
Is it APR 9600 or ARP 9600? If it is APR 9600 sound record/replay IC, check out the link given below. It contains the pin configuration of the IC.
40
It is a data selector. There are 16 digital input lines, 4-bit decoder, strobe and output pin. So you put a 4-bit binary number from 0-15 into ABCD bits and the corresponding input value is found on output at the strobe time.
pin tetel