answersLogoWhite

0

10 Volts.

ANSWER: ASSUMING a start when the voltage is at 0 and 0 degrees at 90 degrees is at maximum at 180 degrees is again at 0 v at 270 degrees is at the maximum negative potential and at 360 degrees is again at 0 v. the voltage is irrelevant in any case but it will follow these rules

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Engineering

What is the Maximum voltage that can be given to a 555 timer?

18 Volts.


What is the break down voltage point for a zenerdiode?

The breakdown voltage point for a Zener diode is 17 volts


Maximum rated voltage for a diode is?

Highly variable, depending on the type. For example a 1N457 is rated for 79 volts, while a 1N4007 is rated for 1200 volts.


What is output voltage on pin1 of UM66?

According to the datasheet the output on pin 1 of that transistor is a maximum 4.5 volts


Is the maximum voltage in an ac circuit when the rms voltage is 110 volts?

It depends on the equipment. The power supplies on most devices can only handle a specific voltage and still work properly. Some, for instance some cell-phone chargers, can handle a range of voltages, say from 110 to 240, which lets them operate in both the States and the UK (where the standard home/office voltage is 230 Volts). Check the label on the back of the device; it will usually show the operating voltage required. Asking the maximum voltage for 110 equipment is valid. 110 means AC voltage that averages 110 volts as it swings above and below 0 volts. The label on a device typically will not tell you the maximum voltage it can withstand if it is plugged into a U.S. 110 volts AC outlet. U.S. houses are wired with 2 hot wires (each 120 Volts AC but opposite of each other) and a neutral wire (0 volts). That way electrical outlets can be wired for 120 Volts AC if they use a hot wire and the neutral wire... or 240 volts AC if they use both of the hot wires. If the neutral line goes bad then the 120 volts AC outlet floats anywhere from 0 volts to 240 volts. I have been in a house when this occurred (the neutral corroded on the transformer that fed several houses). Supplying too high a voltage burned out an air conditioner, a refrigerator, and an incandescent bulb actually burst, scattering glass close to my wife. The air conditioner threw out a lot of smoke so there was a danger of fire. In the U.S. a typical 120 volts AC circuit often has a higher voltage. I have seen specifications and codes that put an upper allowable voltage at 120 volts AC, 137.5 volts AC, and 150 volts AC. Every electrical device has different limits but I would not subject anything built for 120 volts AC to voltages higher than 132 Volts AC unless I had specific knowledge that the device could handle the higher voltage.