yo mama
waz here
10/30/10
It is difficult to define the value which may cause death. I think it the voltage which is dangerous. Approximately a voltage of 50V is dangerous for heart.
It depends of your panel ratings. usualy, a panel short-circuited has a maximum current, you can base the value on that. But if you are doing an array of panels, you have to pai attention to the parallel connection, once that multiplies the current across the circuit. in this case you have to use diodes that support the current of the array.
i think average value of current in ac current is zero.
The secondary load current will change. This, in turn, will cause the primary current to change (the primary current being the phasor sum of the [IS (Np/Ns)] and the primary current (Io).
4444
The fusing current is a value of current that causes the fuse to melt and interrupt the flow of current. Usually, reference is made to the minimum fusing current which is the smallest value of current that will cause the fuse to melt.
The hFe (current gain) on the BC148 ranges from a minimum value of 20 to 100, depending on collector current, with a maximum value of 300.
30 m amp
HOLDING CURRENT: The minimum value of current that must be there to provide a path between anode and cathode to flow anode current and thus maintain a thyristor in the on state.0 LATCHING CURRENT: The minimum anode current required to maintain a thyristor in on-state immediately after a thyristor has be triggered on. IL>IHrate of flow of charge is known as current
program for finding a minimum value in javaprogram for finding a minimum value in java
There is no minimum (nor maximum) value.
You can do either, but some credit sources place limitations on the minimum amounts / minimum percentages that they will loan.
There is no minimum value for the cosecant function.
The pick-up value of an electromechanical relay is the minimum current or voltage required to activate the relay and close its contacts. In contrast, the reset value is the minimum current or voltage needed to de-energize the relay and return it to its original state. These values are crucial for ensuring proper operation and timing in control circuits, as they determine the relay's responsiveness to input signals.
It is difficult to define the value which may cause death. I think it the voltage which is dangerous. Approximately a voltage of 50V is dangerous for heart.
Because to remain in conduction it requires a supply of emitter current. Without a minimum value of emitter current it can't stay in the on position. Most thyristors do not require gate current after they are turned on to remain in conduction
The minimum value is the price it will bring for scrape metal.