Water
A: power company have to have a separate source of power if and when the power faults. To run the computers whereby operators can maintain control. They do have UPS but the power from the jet will not last forever. And the source if it is planned right should come from out of state in case of an earth quake for an example.
AC servomotors require an alternating current as a power source, meaning they need to be plugged into an outlet, while DC servomotors require a direct current as a power source, meaning they can be run off of battery power.
Use a transformer.
Edison was the first to build and run a power station, on a small scale but supplying a number of consumers
If the power tool has brushes to bring the current to the armature it is classed as an universal motor. It will run on DC as long as the voltage is the same potential. On a welding machine the 120 volt receptacle is a DC output and the grinders, drills, etc that are plugged into it work fine.
http://www.answers.com/topic/steam-power-and-engines the answer is yes, go to paragraph 5 starting in 1838
Factories need machinery and power, so to create a factory you would need the machinery to fit your needs and the power to run it.
You need to run a wire from the existing power source to switch to switch to switch to outlet.
It uses a free energy source that will not run out.
It uses a free energy source that will not run out.
It uses a free energy source that will not run out.
To wire 2 lights to 1 switch when the power source is at one of the lights, you will need to connect the power source to the first light, then run a wire from the first light to the second light, and finally connect both lights to the switch. This setup will allow you to control both lights with a single switch.
Because they provided water power to run the machinery and a place to dump their waste
At the beginning of the Industrial Revolution, factories were commonly built next to flowing rivers or other water source because people used the water as an energy source to run the machines in the factory.
To run electricity to a shed, you will need to first determine the power source, such as an existing electrical panel or a separate circuit. Then, you will need to bury a conduit from the power source to the shed and run electrical wires through it. Finally, install a subpanel in the shed to distribute the electricity safely. It is important to follow local building codes and regulations when doing this project.
stabilizing power source and providing temporary power source in case of power outage to allow equipment to run uninterrupted through such power outage
You need suitable DC power source to run it.