0
What else can I help you with?
Where failure will occur in cotter joint?
When the axial loads(Tensile/Compressive) will rise above the strength of specially designed socket , spigot and cotter. The failure may be of anyone component or together.
What type of material used for cotter joint?
why what type of material is used?which are the manufacturing companies?what are its standard dimension?Cotter jointThese types of joints are used to connect the end of a rod or bar to a shaft. The end of the bar has a hole in it and it is called a lug. The hole carries a shaft. This shaft is locked in place by a smaller pin that passes through the side of the lug and partly or completely through the shaft itself. This locking pin is named a cotter, which sometimes is also applied to the whole joint.The obvious example is on a bicycle where both pedal bars are separately locked by a cotter pin, on their common driving shaft having the sprocket wheel.Steel is the most common material used for this application. There are no specific manufacturing companies who make only cotter pins, nor are there any dimensional standards by which they are designed.
Show the pictures of cotter joints?
A cotter joint is one that is used to hold parts that might turn, as in an axle or a drive shaft. For example, on a child's wagon, the axles have a hole in each outside end. This hole is for a cotter pin (it looks similar to a bobby pin for the hair), that helps to keep the wheel on while the wheel is turning.
What is the purpose for plumbing pipe dope?
Joint compound AKA dope is used as a lubricant and to seal minor imperfections of the threads
What is the difference between a DIP joint and a PIP joint?
Distal interphalengeal joint & Proximal interphalengeal joint
Cotter joint is used transmit which type of loads?
Cotter Joint is used to transmit Axial Forces..... ie tensile force.
Why Clearence is Provider in Cotter Joint?
Clearances between the cotter and slots in the rod end and socket allows the driven cotter to draw together the two parts of the joint until the socket end comes in contact with the cotter on the rod end.
What are the examples of cotter joint?
*joint between the piston rod and and the crosshead of the steam engine *joint between the slide spindle and the fork of the valve mechanism *joint between the piston rod and the tail
How much and why taper is given in cotter joint?
1:30
How do you get the bolt on the ball joint to stay on it keeps coming loose?
install a cotter pin in the hole in the shaft of the ball joint
Where do you use cotter joint?
A cotted joint is usually wedge shaped and is generally used to coonect two rods rigidly.
What is the purpose of joint doctrine?
To enhance effectiveness of joint forces by providing fundamental principles that guide the employment if US military forces toward a common objective.
Where failure will occur in cotter joint?
When the axial loads(Tensile/Compressive) will rise above the strength of specially designed socket , spigot and cotter. The failure may be of anyone component or together.
What is the torque specs for upper and lower ball joints on a 1999 Dodge Dakota?
Top ball joint is 60 ft.lbs., initial. Then tighten to align hole for cotter pin. Bottom ball joint is 94 ft.lbs., initial. Then tighten to align hole for cotter pin
What is a purpose of a joint?
its a joint that flexes
Who enters the data into the joint clearance and access verification?
CAF
Who enters the access data into the joint clearance and access?
CAF
