if the input is changed then the output is also changed.
You can't determine the output voltage of a transformer by knowing kva. Transformers will be marked as to input and output voltages. Some will have multiple input and output voltages. The output voltage depends on the ratio of coil turns between input and output.
Alternator output voltages are typically restricted to around 25 kV to limit their physical size and the centrifugal forces to which they are subjected. In the UK, this voltage is then typically raised to 400 kV for transmission.The voltages to which you are referring to are typical of the voltages used in the UK's high-voltage distribution system. 'Grid' substations typically transform transmission voltages of 132 kV down to 33 kV (or, less commonly, 66 kV), and 'primary' substations then transform distribution voltages of 33 kV down to 11 kV.
The op amp can only output so high a voltage; this is limited by the positive and negative voltages applied to the op amp. Your input signal is too strong, or your amplifier is set up to have too much gain.
The input voltage range for the Toshiba power supply is AC 100V - 240V. The output voltage is DC 19V / output current is 4.74A. This power supply comes with a power cord and packaging will state voltage recommended for the product.
if the input is changed then the output is also changed.
input 220v ac & output 24v dc
Comparator is basically,which allows more than one voltages and currents to be in its output...
A power supply unit (PSU) converts mains AC to low-voltage regulated DC power for the internal components of a computer. PSU is a output device because it is outputting power to the rest of the device. Most personal computers can be plugged into standard electrical outlets.
add the signal voltages by connecting them in series - to +
if a sinusoidal voltage is applied to linear circuit the output voltage is also sinusoidal in nature as far as the waveform is concerned the amplitude of input signal may change and there may be phase displacement between input voltages and output voltages
An ATX power supply unit delivers power in three voltages: 3.3 volts, 5 volts, and 12 volts. The 3.3 volt pins are used only in the motherboard connector. Older, AT power supplies and motherboards used only 5 volt and 12 volt pins in the motherboard connection.
A voltage divider is an electrical circuit that divides the input voltage into smaller output voltages. It consists of two resistors connected in series. The output voltage is determined by the ratio of the two resistors. The formula for calculating the output voltage is Vout Vin (R2 / (R1 R2)), where Vin is the input voltage, R1 is the resistance of the first resistor, R2 is the resistance of the second resistor, and Vout is the output voltage.
Average value of the conducting phase voltages
In North America there are two standard voltages for the wiring of homes, 120/240 volts.
Your power supply unit, PSU. Takes AC power and distributes so much power to each connector. Each PSU, depending on the wattage of the unit gives each connector so much voltage. Each connector is designed for a certain piece of hardware that requires different voltage.
No. It is a Navratna PSU