0
What else can I help you with?
What type of interface circuit is required between the MPU data lines and a 7 segment display?
a latch
Where circuit breaker are used?
Circuit breakers do not use anything, they are a controlling device. They can automatically open the circuit if the current exceeds the current rating and you can manually disconnect the power from the circuit.
Part of a circuit that does work?
Three basic parts of a circuit are: 1. Active components = source of energy 2. Transmission Lines = wiring and control devices 3. Passive components = load or user of energy
How tall are the power lines in Ontario?
An ammeter is a measuring instrument used to measure the electric current in a circuit. Electric currents are measured in amperes (A), hence the name
What is the function of monitoring voltage relay?
A voltage monitor relay is in the circuit for one reason. It monitors the incoming voltage to the equipment that it is protecting usually on three phase control panels.The relay monitors the three incoming line voltages and in some relays the voltage to ground (wye connection). If the circuit the relay is protecting looses one of the voltage legs, the circuit will shut down until the problem is rectified. This usually happens if a fuse blows in one of the three phase voltage legs.It also monitors the level of voltage to the circuit. If the voltage drops due to a malfunction in the utility lines the relay will trip and take the protected circuit off line. The voltages can be set to trip at any under or over voltage usually by set point controls on the front of the voltage monitoring relay.
On a electrical diagram a dashed line indicates?
On an electrical diagram, a dashed line typically indicates a connection that is not physically present or is not visible, such as a connection made through a circuit board or a hidden wire. It may also represent a signal or control line rather than a power line. Additionally, dashed lines can denote optional or secondary components in the circuit.
What are the distributed and lumped circuit?
The circuit is callaed lumped circuit whose elements can seprate(eg rectifier circuit in pcb). but in the distributed circuit we can seprate the elements from the circuit(eg transmision lines)
Symbol used for a connecting wire?
In a circuit diagram a connecting wire is shown as a straight line. <<>> On an electrical schematic where two lines intersect each other, a black dot represents a connection at that point. If there is no black dot, the intersecting lines just cross each other.
Why put a multiplexer at the end of a circuit?
Multiplexers are used to transfer many signals over one line, and several control lines. You put it at the end of a circuit if you plan to send the output from that circuit to another circuit, so you use the least lines possible.
What are computer circuit lines?
a thing that works in a computer.
3 pole circuit breakers?
3 pole circuit breakers are used for 3 phase lines
How is a parallel curcuit different from a series curcuit?
a parallel circuit is in lines and a series circuit is one circle
What does short-circuited mean?
Short circuit is when two phases or lines on the power circuit has be abruptly bridged, causing a protected electrical circuit to trip.
What do long straight lines represent in a circuit diagram?
They are the wires through which current flows when the circuit is closed.
A is a temporary connection that uses one or more analog telephone lines for connection?
dial-up line
What does the fuel rail do?
It is the connection between the fuel lines and the injectors.
What would you read if you connect two phases of a wye electrical connection together between phase and neutral?
I think you probably mean 'lines', rather than 'phases' but, even so, your question is still confusing. However, if you connect any two lines together directly, you will create a line-to-line short circuit fault; if you connect any line and neutral together directly, you will create a line-to-neutral short circuit fault.
