The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
pull the toilet. Make sure the trap is clear on the toilet, and then snake the toilet line.
either the vert is plugged and there is no air getting through or there is no vent at all
Grey is usually dirty water but not toilet water (shower, sink drain) Black (or Brown) is sewage from the toilet. If you have a motorhome there will be two sewage tanks... "grey" and "black"
You can't fill a toilet drain not in use as there is no 'trap' to fill with water. The best thing is to get a toilet flange cover from a plumbing store and install it on the toilet flange - i.e. the circular fitting in the floor that the toilet would normally sit on.By simple pouring a few gallons of cold water to replenish the trap seal of the fixture .. check it every few weeks to make sure there is still water above the crown weir
The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
pull the toilet. Make sure the trap is clear on the toilet, and then snake the toilet line.
To drain a toilet properly, turn off the water supply valve located behind the toilet. Flush the toilet to remove most of the water. Use a plunger to push any remaining water down the drain. You can also use a wet/dry vacuum to remove water if needed.
noob
Drain all the water lines. If you cannot drain the water lines then use a compressor to blow the water out. Pour RV anti-freeze in all the toilet bowls, and toilet tanks. Pour the anti-freeze in all sink and bathtub drains.
To completely drain a toilet, turn off the water supply valve located behind or near the toilet. Then, flush the toilet to remove as much water as possible. Use a plunger to push any remaining water out of the bowl and into the drain. You can also use a wet/dry vacuum to suction out any remaining water.
The wax ring which seals the toilet to the drain is leaking. turn off water, drain tank by flushing. Disconnect water line. remove tank, unbolt toilet from floor. Remove any old wax from toilet and drain. Replace with new wax ring. Reset toilet and press firmly into place.
Water runs in the toilet bowl to maintain proper water levels and to flush waste down the drain when the toilet is flushed.
To fully drain a toilet, turn off the water supply valve located behind or near the toilet. Then, flush the toilet to remove as much water as possible. Use a plunger to push any remaining water out of the bowl and into the drain. Finally, use a wet/dry vacuum to suction out any remaining water in the bowl and tank.
To effectively remove all the water from a toilet, you can use a plunger to push the water down the drain or use a wet/dry vacuum to suction out the water. You can also try using a bucket to scoop out the water manually.
The purpose of the water pipe in a toilet system is to supply water to the toilet tank, which is necessary for flushing waste down the drain.
Do the rest of the fixtures in the bathroom drain well? If they do not drain well, my guess would be the venting of the plumbing system. If all of the other fixtures in the bathroom drain well, then there is probably something in the trapway of the toilet. Assuming it is just the toilet that is having problems, then a closet auger might do the trick. Hope it helps.