By increasing Vr,Reducing in series inductance,increase capacitance
Conductance is ignored in short circuit studies because the inductance of the line is the dominant value. Conductance may not be ignored in stability studies.
they should possess low inductance as the sparking will be less during the time of opening
the basic parameters of transmission lines are R,L,C and G...........
Inductance is inductance, and is not a function of frequency. Frequency affects reactance, and ultimately impedance, not inductance.
By increasing Vr,Reducing in series inductance,increase capacitance
resistance (R) inductance(L) capacitance(C) shunt conductance(G)
Capacitors can be used to decrease the inductance of power lines (series compensation), and for voltage support (capacitors are put in parallel with the system).
Conductance is ignored in short circuit studies because the inductance of the line is the dominant value. Conductance may not be ignored in stability studies.
they should possess low inductance as the sparking will be less during the time of opening
Self-inductance in a coaxial cable is significant because it creates a magnetic field around the cable when current flows through it. This magnetic field can interfere with the transmission of signals by causing signal loss or distortion. To minimize this effect, coaxial cables are designed with specific spacing and materials to reduce self-inductance and improve signal transmission quality.
You can disconnect the 1996 Jeep transmission lines with a 9/16 open end wrench. Be prepared for transmission fluid to come out of the transmission lines.
if you are asking about the cooling lines for the transmission that connect to the radiator, its easy. first disconnect the lines from the radiator (2 lines, usually on the bottom opposite the radiator outlet) then disconnect the lines from the transmission. remove the brackets holding them on, then remove.
The major material used in the construction of transmission lines is aluminum alloy. Steel is also used to reinforce the lines. No insulation is used for overhead transmission lines.
the basic parameters of transmission lines are R,L,C and G...........
There are no vacuum lines running to the automatic transmission.
Inductance is inductance, and is not a function of frequency. Frequency affects reactance, and ultimately impedance, not inductance.